UK · EU reference Tyre Pressure

Toyota · Tundra · Cold

Setting cold tyres on a Toyota Tundra

Drivetrain
rear-wheel drive
Body
pickup / double-cab
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

psi

34 / 34

Catalogue mid-points, front / rear · 2.2-2.4 / 2.2-2.4 bar

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

Cold means the Toyota Tundra has stood at least three hours, or covered less than about a mile. Heat from a dual carriageway run is not the number you set. Size estimates on this page include 285/70R17, LT245/75R16 and 255/65R17 — interpolated from the catalogue midpoint, not a second factory sticker. Commercial and load-biased bodies like this pickup / double-cab often need a higher rear; LT or C-type sizes such as 255/65R17 are not filled like a Fiesta.

Temperature and a cold gauge

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this Tundra.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

How to set the Tundra

  1. Measure before the school run, not after the M25.
  2. Write LF / RF / RR / RL. Do not keep Tundra numbers in your head.
  3. Add air in short bursts toward 34 psi (2.31 bar) front and 34 psi rear.
  4. If one corner is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Toyota Tundra placard versus sidewall

The tyre-information placard on a Toyota Tundra sits on the driver’s door pillar (sometimes the fuel-filler flap). Catalogue figures here are a general band: 32-35 / 32-35 psi.

Estimated pressure by tyre size (285/70R17 and others)

285/70R17 is the first planning size here. 255/65R17 is usually the plus-size or LT step. Keep load index at or above original equipment.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
285/70R1738412.622.83262283Wide all-terrain
LT245/75R1642462.93.17290317LT-metric, higher load
255/65R1737392.552.69255269Highway 17-inch
245/70R1636382.482.62248262Common 16-inch all-terrain
235/75R1535372.412.55241255Older compact truck
265/70R1737392.552.69255269Typical 17-inch load tyre
LT265/70R1742482.93.31290331LT 17-inch
275/65R1837402.552.76255276Plus-size 18-inch

PSI, bar and kPa

PSI-led conversions for the Toyota Tundra band (32-35 / 32-35).

PSIBarkPa
302.07207
322.21221
332.28228
33.52.31231
352.41241
362.48248
382.62262
402.76276
443.03303
503.45345
604.14414

Load notes

Load moves the rear of a pickup / double-cab first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy35 psi / 2.41 bar36 psi / 2.48 bar
Payload / towing36 psi / 2.48 bar38 psi / 2.62 bar

Toyota notes

Toyota trucks print front and rear separately more often than cars. A roof box on a RAV4 is a load condition, not a forum “add 5 psi” rule.

Spare and inflator kit

A matching full-size spare on the Toyota Tundra usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

A cheap gauge and a monthly habit will do more for this Tundra than nitrogen upsells.

Other Toyota models

Questions about this Tundra

Front versus rear on the Toyota Tundra?

This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

When does TPMS warn on a Toyota Tundra?

Direct TPMS typically flags about 25% below placard — near 25 psi on this row. Fill to the sticker, not to the lamp.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

What is that in bar and kPa for the Tundra?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

Is the sidewall number correct on a Toyota Tundra?

No. Sidewall PSI is a maximum. The Tundra placard is the operating target, near 32-35/32-35 psi.

Handbook: placard · bar vs PSI · front vs rear · cold inflation