UK · EU reference Tyre Pressure

255/65R17 · pickup / double-cab · PSI

What PSI for 255/65R17 tyres?

Size
255/65R17
Class
pickup / double-cab
Planning PSI
36
Planning bar
2.48

psi

36

2.48 bar · 248 kPa · pickup / double-cab planning figure

255/65R17 · 36 psi · 2.48 bar · 248 kPa — estimates. Placard wins.

PSI is the garage-hose number. For 255/65R17 a typical pickup / double-cab planning figure is 36 psi cold — about 2.48 bar or 248 kPa. TPMS typically warns near 27 psi (about 25% below a 36 psi target). That is already a soft tyre.

Estimated 255/65R17 pressure by load

These 255/65R17 load steps are ± a few PSI from 36. They are not a licence to ignore a printed second column on a van or estate.

ConditionFront (est.)Rear (est.)
Driver only / unladen36 psi / 2.48 bar / 248 kPa38 psi / 2.62 bar / 262 kPa
Typical occupancy37 psi / 2.55 bar / 255 kPa40 psi / 2.76 bar / 276 kPa
Payload / towing (sketch)38 psi / 2.62 bar / 262 kPa41 psi / 2.83 bar / 283 kPa

PSI, bar and kPa

1 bar ≈ 14.5 psi; 1 psi ≈ 6.89 kPa. Planning midpoint for 255/65R17: 36 psi = 2.48 bar = 248 kPa.

PSIBarkPa
322.21221
332.28228
342.34234
352.41241
362.48248
372.55255
382.62262
392.69269
402.76276
412.83283
422.90290
432.96296
443.03303
453.10310
463.17317
473.24324
483.31331

What 255/65R17 means

A 255/65R17 on a pickup / double-cab is a geometry. Two cars can share the size and disagree on PSI because mass and axle split differ.

Wide 17-inch truck / SUV. Rim diameter 17 in; section 255 mm. Estimates on this page assume a typical load index for the pickup / double-cab class.

Placard versus sidewall

The sidewall of a 255/65R17 may say 51 psi or 350 kPa. That is a carcass maximum. Operating pressure is the tyre-information placard on the driver’s door pillar.

Cars often seen on 255/65R17

These catalogue models are often seen on 255/65R17 or a close OEM neighbour. Open the vehicle chart for axle-specific PSI and bar.

How to set 255/65R17

  1. Measure before the school run, not after the motorway.
  2. Write LF / RF / RR / RL. Do not keep 255/65R17 numbers in your head.
  3. Add air in short bursts toward the placard, using 36 psi only as a map.
  4. If one 255/65R17 is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 36 psi as a 20 °C baseline for 255/65R17.

AmbientGaugeBarkPaNote
−5 °C (hard frost)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
0 °C34 psi2.34 bar234 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)35 psi2.41 bar241 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)36 psi2.48 bar248 kPaBaseline for this size sketch
30 °C38 psi2.62 bar262 kPaDo not bleed a hot 255/65R17
38 °C (heatwave tarmac)39 psi2.69 bar269 kPaDo not bleed a hot 255/65R17

Keep 255/65R17 on the printed band for that car; 36 psi is a size sketch, not a second VIN label.

Questions about 255/65R17

What is 255/65R17 in kPa?

248 kPa is the planning midpoint (100 kPa = 1 bar). 255 kPa is one PSI higher.

What is 255/65R17 in bar?

36 psi is 2.48 bar. Add a tenth of a bar if the placard’s laden column is higher, which is common on vans that wear this size.

When does TPMS warn on 255/65R17?

Direct TPMS typically flags about 25% below target — near 27 psi if you were aiming at 36. Fill to the sticker, not to the lamp.

Is the sidewall number correct for 255/65R17?

No. Sidewall PSI or kPa is a maximum for the carcass. Operating pressure is the door-pillar placard.

Is 255/65R17 the same as a plus-size swap?

Only if that is the size you fitted. Overall diameter should stay close to OEM. Pressure still follows the car, with load index at or above original.

Handbook: placard · bar vs PSI · cold inflation · all sizes