LT245/75R16 · LT-metric truck · PSI
LT245/75R16 PSI chart (55 psi planning figure)
- Size
- LT245/75R16
- Class
- LT-metric truck
- Planning PSI
- 55
- Planning bar
- 3.79
psi
55
3.79 bar · 379 kPa · LT-metric truck planning figure
LT245/75R16 · 55 psi · 3.79 bar · 379 kPa — estimates. Placard wins.
If someone typed “LT245/75R16 psi”, they want Imperial. Start near 55 psi on an unladen LT-metric truck, then confirm the vehicle placard. Sidewall max is not the target. Under-inflation cooks the shoulders of a LT245/75R16; over-inflation wears the centre rib and bangs every cat’s eye. LT-metric sizes print a load range. The vehicle door sticker, not the LT sidewall maximum, is still the operating pressure.
Estimated LT245/75R16 pressure by load
These LT245/75R16 load steps are ± a few PSI from 55. They are not a licence to ignore a printed second column on a van or estate.
| Condition | Front (est.) | Rear (est.) |
|---|---|---|
| Driver only / unladen | 55 psi / 3.79 bar / 379 kPa | 59 psi / 4.07 bar / 407 kPa |
| Typical occupancy | 56 psi / 3.86 bar / 386 kPa | 61 psi / 4.21 bar / 421 kPa |
| Payload / towing (sketch) | 57 psi / 3.93 bar / 393 kPa | 68 psi / 4.69 bar / 469 kPa |
PSI, bar and kPa
Convert around the LT245/75R16 band. 3.79 bar is about 55 psi — not 23, not 33 unless the maths says so.
| PSI | Bar | kPa |
|---|---|---|
| 44 | 3.03 | 303 |
| 46 | 3.17 | 317 |
| 50 | 3.45 | 345 |
| 51 | 3.52 | 352 |
| 52 | 3.59 | 359 |
| 53 | 3.65 | 365 |
| 54 | 3.72 | 372 |
| 55 | 3.79 | 379 |
| 56 | 3.86 | 386 |
| 57 | 3.93 | 393 |
| 58 | 4.00 | 400 |
| 59 | 4.07 | 407 |
| 60 | 4.14 | 414 |
| 61 | 4.21 | 421 |
| 62 | 4.27 | 427 |
| 63 | 4.34 | 434 |
| 64 | 4.41 | 441 |
| 65 | 4.48 | 448 |
| 66 | 4.55 | 455 |
| 67 | 4.62 | 462 |
| 80 | 5.52 | 552 |
What LT245/75R16 means
Read LT245/75R16 as width / aspect R rim. Nothing in the size string is a pressure. Pressure lives on the car, not moulded as 205 or 55.
Common LT half-ton 16-inch. Rim diameter 16 in; section 245 mm. Estimates on this page assume a typical load index for the LT-metric truck class.
Placard versus sidewall
If a forum says “all LT245/75R16 run 55 psi”, ignore it. A Qashqai and a Golf can share a size and not share a sticker.
Cars often seen on LT245/75R16
These catalogue models are often seen on LT245/75R16 or a close OEM neighbour. Open the vehicle chart for axle-specific PSI and bar.
How to set LT245/75R16
- Measure before the school run, not after the motorway.
- Write LF / RF / RR / RL. Do not keep LT245/75R16 numbers in your head.
- Add air in short bursts toward the placard, using 55 psi only as a map.
- If one LT245/75R16 is 4 psi down, hunt for a nail before you blame the weather.
- Log date, ambient temperature and the four readings.
Temperature drift
Roughly 1 psi per 5–6 °C. The table uses 55 psi as a 20 °C baseline for LT245/75R16.
| Ambient | Gauge | Bar | kPa | Note |
|---|---|---|---|---|
| −5 °C (hard frost) | 52 psi | 3.59 bar | 359 kPa | Gauge reads low; do not overfill once warm |
| 0 °C | 53 psi | 3.65 bar | 365 kPa | Gauge reads low; do not overfill once warm |
| 8 °C (UK winter morning) | 54 psi | 3.72 bar | 372 kPa | Gauge reads low; do not overfill once warm |
| 20 °C (set cold here) | 55 psi | 3.79 bar | 379 kPa | Baseline for this size sketch |
| 30 °C | 57 psi | 3.93 bar | 393 kPa | Do not bleed a hot LT245/75R16 |
| 38 °C (heatwave tarmac) | 58 psi | 4 bar | 400 kPa | Do not bleed a hot LT245/75R16 |
A cheap gauge and a monthly habit will do more for a set of LT245/75R16 than nitrogen upsells.
Questions about LT245/75R16
What is LT245/75R16 in bar?
55 psi is 3.79 bar. Add a tenth of a bar if the placard’s laden column is higher, which is common on vans that wear this size.
What is LT245/75R16 in kPa?
379 kPa is the planning midpoint (100 kPa = 1 bar). 386 kPa is one PSI higher.
Should I bleed pressure after a motorway run?
No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.
Can I run LT245/75R16 at a lower pressure for comfort?
Not as a habit. A soft LT245/75R16 cooks the shoulders and dulls steering. Keep load index and stay on the placard.
What PSI should LT245/75R16 tyres be?
A LT-metric truck planning figure is about 55 psi cold (3.79 bar / 379 kPa). Confirm on the vehicle placard — two cars can share LT245/75R16 and not share a sticker.
Handbook: placard · bar vs PSI · cold inflation · all sizes