UK · EU reference Tyre Pressure

275/65R18 · pickup / double-cab · PSI

What PSI for 275/65R18 tyres?

Size
275/65R18
Class
pickup / double-cab
Planning PSI
37
Planning bar
2.55

psi

37

2.55 bar · 255 kPa · pickup / double-cab planning figure

275/65R18 · 37 psi · 2.55 bar · 255 kPa — estimates. Placard wins.

PSI is the garage-hose number. For 275/65R18 a typical pickup / double-cab planning figure is 37 psi cold — about 2.55 bar or 255 kPa. TPMS typically warns near 28 psi (about 25% below a 37 psi target). That is already a soft tyre.

Estimated 275/65R18 pressure by load

Load moves the rear first on a pickup / double-cab. If the factory placard already has a laden column, use that — not this sketch for 275/65R18.

ConditionFront (est.)Rear (est.)
Driver only / unladen37 psi / 2.55 bar / 255 kPa40 psi / 2.76 bar / 276 kPa
Typical occupancy38 psi / 2.62 bar / 262 kPa42 psi / 2.9 bar / 290 kPa
Payload / towing (sketch)39 psi / 2.69 bar / 269 kPa43 psi / 2.96 bar / 296 kPa

PSI, bar and kPa

Convert around the 275/65R18 band. 2.55 bar is about 37 psi — not 23, not 33 unless the maths says so.

PSIBarkPa
332.28228
342.34234
352.41241
362.48248
372.55255
382.62262
392.69269
402.76276
412.83283
422.90290
432.96296
443.03303
453.10310
463.17317
473.24324
483.31331
493.38338

What 275/65R18 means

275/65R18 means a 275 millimetre section width, a sidewall that is 65 percent of that width, on a 18-inch rim. The R is radial construction.

Plus-size 18-inch truck. Rim diameter 18 in; section 275 mm. Estimates on this page assume a typical load index for the pickup / double-cab class.

Placard versus sidewall

This website maps size searches such as “275/65R18 psi”. It does not replace the VIN label. If the two disagree, the label wins.

Cars often seen on 275/65R18

These catalogue models are often seen on 275/65R18 or a close OEM neighbour. Open the vehicle chart for axle-specific PSI and bar.

How to set 275/65R18

  1. Measure before the school run, not after the motorway.
  2. Write LF / RF / RR / RL. Do not keep 275/65R18 numbers in your head.
  3. Add air in short bursts toward the placard, using 37 psi only as a map.
  4. If one 275/65R18 is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 37 psi as a 20 °C baseline for 275/65R18.

AmbientGaugeBarkPaNote
−5 °C (hard frost)34 psi2.34 bar234 kPaGauge reads low; do not overfill once warm
0 °C35 psi2.41 bar241 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)36 psi2.48 bar248 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)37 psi2.55 bar255 kPaBaseline for this size sketch
30 °C39 psi2.69 bar269 kPaDo not bleed a hot 275/65R18
38 °C (heatwave tarmac)40 psi2.76 bar276 kPaDo not bleed a hot 275/65R18

A cheap gauge and a monthly habit will do more for a set of 275/65R18 than nitrogen upsells.

Questions about 275/65R18

Can I run 275/65R18 at a lower pressure for comfort?

Not as a habit. A soft 275/65R18 cooks the shoulders and dulls steering. Keep load index and stay on the placard.

Is the sidewall number correct for 275/65R18?

No. Sidewall PSI or kPa is a maximum for the carcass. Operating pressure is the door-pillar placard.

What PSI should 275/65R18 tyres be?

A pickup / double-cab planning figure is about 37 psi cold (2.55 bar / 255 kPa). Confirm on the vehicle placard — two cars can share 275/65R18 and not share a sticker.

When does TPMS warn on 275/65R18?

Direct TPMS typically flags about 25% below target — near 28 psi if you were aiming at 37. Fill to the sticker, not to the lamp.

What is 275/65R18 in kPa?

255 kPa is the planning midpoint (100 kPa = 1 bar). 262 kPa is one PSI higher.

Handbook: placard · bar vs PSI · cold inflation · all sizes