Honda · Ridgeline · Cold
Setting cold tyres on a Honda Ridgeline
- Drivetrain
- rear-wheel drive
- Body
- pickup / double-cab
- PSI F / R
- 32-35 / 32-35
- Bar F / R
- 2.2-2.4 / 2.2-2.4
psi
34 / 34
Catalogue mid-points, front / rear · 2.2-2.4 / 2.2-2.4 bar
32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa
Cold means the Honda Ridgeline has stood at least three hours, or covered less than about a mile. Heat from a dual carriageway run is not the number you set. TPMS typically warns near 25 psi (about 25% below target). That is already a soft tyre, not a fill target. Commercial and load-biased bodies like this pickup / double-cab often need a higher rear; LT or C-type sizes such as LT245/75R16 are not filled like a Fiesta.
Temperature and a cold gauge
Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this Ridgeline.
| Ambient | Gauge (front mid) | Bar | kPa | Note |
|---|---|---|---|---|
| −5 °C (hard frost) | 31 psi | 2.14 bar | 214 kPa | Gauge reads low; do not overfill once warm |
| 0 °C | 32 psi | 2.21 bar | 221 kPa | Gauge reads low; do not overfill once warm |
| 8 °C (UK winter morning) | 33 psi | 2.28 bar | 228 kPa | Gauge reads low; do not overfill once warm |
| 20 °C (set cold here) | 34 psi | 2.34 bar | 234 kPa | Baseline |
| 30 °C | 36 psi | 2.48 bar | 248 kPa | Do not bleed a hot tyre |
| 38 °C (heatwave tarmac) | 37 psi | 2.55 bar | 255 kPa | Do not bleed a hot tyre |
How to set the Ridgeline
- Park the Honda Ridgeline for at least three hours (cold tyres).
- Use a calibrated gauge, not the only meter on a forecourt hose.
- Set the placard for that axle — about 32-35 psi / 2.2-2.4 bar front and 32-35 psi / 2.2-2.4 bar rear on this catalogue row.
- Recheck all four. A 2 psi miss on a rear-wheel drive Ridgeline is enough to feel a pull.
- Refit valve caps and reset TPMS if the handbook asks for a relearn.
Honda Ridgeline placard versus sidewall
The tyre-information placard on a Honda Ridgeline sits on the driver’s door pillar (sometimes the fuel-filler flap). Catalogue figures here are a general band: 32-35 / 32-35 psi.
Estimated pressure by tyre size (255/65R17 and others)
Planning cold pressures for sizes often seen on a pickup / double-cab. This Ridgeline sample opens with 255/65R17, then LT265/70R17 and LT245/75R16.
| Tyre size | Front PSI | Rear PSI | Front bar | Rear bar | Front kPa | Rear kPa | Note |
|---|---|---|---|---|---|---|---|
| 255/65R17 | 37 | 39 | 2.55 | 2.69 | 255 | 269 | Highway 17-inch |
| LT265/70R17 | 42 | 48 | 2.9 | 3.31 | 290 | 331 | LT 17-inch |
| LT245/75R16 | 42 | 46 | 2.9 | 3.17 | 290 | 317 | LT-metric, higher load |
| 285/70R17 | 38 | 41 | 2.62 | 2.83 | 262 | 283 | Wide all-terrain |
| 245/70R16 | 36 | 38 | 2.48 | 2.62 | 248 | 262 | Common 16-inch all-terrain |
| 265/70R17 | 37 | 39 | 2.55 | 2.69 | 255 | 269 | Typical 17-inch load tyre |
| 275/65R18 | 37 | 40 | 2.55 | 2.76 | 255 | 276 | Plus-size 18-inch |
| 235/75R15 | 35 | 37 | 2.41 | 2.55 | 241 | 255 | Older compact truck |
PSI, bar and kPa
PSI-led conversions for the Honda Ridgeline band (32-35 / 32-35).
| PSI | Bar | kPa |
|---|---|---|
| 30 | 2.07 | 207 |
| 32 | 2.21 | 221 |
| 33 | 2.28 | 228 |
| 33.5 | 2.31 | 231 |
| 35 | 2.41 | 241 |
| 36 | 2.48 | 248 |
| 38 | 2.62 | 262 |
| 40 | 2.76 | 276 |
| 44 | 3.03 | 303 |
| 50 | 3.45 | 345 |
| 60 | 4.14 | 414 |
Load notes
Load moves the rear of a pickup / double-cab first. If the factory placard already has a “laden” column, use that instead of these sketches.
| Condition | Front (est.) | Rear (est.) |
|---|---|---|
| Driver only | 34 psi / 2.34 bar | 34 psi / 2.34 bar |
| Full occupancy | 35 psi / 2.41 bar | 36 psi / 2.48 bar |
| Payload / towing | 36 psi / 2.48 bar | 38 psi / 2.62 bar |
Honda notes
Honda cars cluster around 32–35 psi (2.2–2.4 bar). Reset the TPMS from the cluster after a large fill on many 2008+ models.
Spare and inflator kit
A matching full-size spare on the Honda Ridgeline usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.
If the Honda sticker and this page disagree, the sticker wins.
Other Honda models
Questions about this Ridgeline
Front versus rear on the Honda Ridgeline?
This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.
What is that in bar and kPa for the Ridgeline?
Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.
What tyre pressure should a Honda Ridgeline use?
Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.
Should I bleed pressure after a motorway run?
No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.
What PSI if I plus-size toward LT245/75R16?
Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 255/65R17, LT265/70R17 and LT245/75R16 as a planning band.
Handbook: placard · bar vs PSI · front vs rear · cold inflation