UK · EU reference Tyre Pressure

Trucks-Lkw · Peugeot · Overview

Trucks-Lkw Peugeot tyre pressure

Drivetrain
front-wheel drive
Body
light commercial
PSI F / R
35-45 / 45-65
Bar F / R
2.4-3.1 / 3.1-4.5

psi

40 / 55

Catalogue mid-points, front / rear · 2.4-3.1 / 3.1-4.5 bar

35-45 psi F · 45-65 psi R · 2.4-3.1 / 3.1-4.5 bar · 276/379 kPa

The Trucks-Lkw Peugeot catalogue band is 35-45 psi front and 45-65 psi rear — 2.4-3.1 / 3.1-4.5 bar, or about 276 / 379 kPa — measured cold. Under-inflation cooks the shoulders of a Peugeot; over-inflation wears the centre rib and bangs every cat’s eye.

PSI, bar and kPa

1 bar ≈ 14.5 psi; 1 psi ≈ 6.89 kPa. Mid-points on the Peugeot: 40 psi = 2.76 bar = 276 kPa.

PSIBarkPa
352.41241
362.48248
382.62262
402.76276
443.03303
453.10310
503.45345
553.79379
604.14414
654.48448

Temperature and a cold gauge

Roughly 1 psi per 5–6 °C. The table uses 40 psi as a 20 °C baseline for this Peugeot.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)37 psi2.55 bar255 kPaGauge reads low; do not overfill once warm
0 °C38 psi2.62 bar262 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)39 psi2.69 bar269 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)40 psi2.76 bar276 kPaBaseline
30 °C42 psi2.9 bar290 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)43 psi2.96 bar296 kPaDo not bleed a hot tyre

Pressure against load

Load moves the rear of a light commercial first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only40 psi / 2.76 bar55 psi / 3.79 bar
Full occupancy41 psi / 2.83 bar57 psi / 3.93 bar
Motorway + luggage42 psi / 2.9 bar57 psi / 3.93 bar

How to set the Peugeot

  1. Park the Trucks-Lkw Peugeot for at least three hours (cold tyres).
  2. Use a calibrated gauge, not the only meter on a forecourt hose.
  3. Set the placard for that axle — about 35-45 psi / 2.4-3.1 bar front and 45-65 psi / 3.1-4.5 bar rear on this catalogue row.
  4. Recheck all four. A 2 psi miss on a front-wheel drive Peugeot is enough to feel a pull.
  5. Refit valve caps and reset TPMS if the handbook asks for a relearn.

Spare and inflator kit

A matching full-size spare on the Trucks-Lkw Peugeot usually follows the higher axle (often the rear, near 45-65 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

Estimated pressure by tyre size (255/65R17 and others)

If your Trucks-Lkw Peugeot no longer wears the OEM diameter, start at the row nearest 255/65R17 or 265/70R17 and confirm with the tyre maker’s load table.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
255/65R1743602.964.14296414Highway 17-inch
265/70R1743602.964.14296414Typical 17-inch load tyre
LT265/70R1748693.314.76331476LT 17-inch
275/65R1843612.964.21296421Plus-size 18-inch
245/70R1642592.94.07290407Common 16-inch all-terrain
285/70R1744623.034.27303427Wide all-terrain
LT245/75R1648673.314.62331462LT-metric, higher load
235/75R1541582.834283400Older compact truck

Trucks-Lkw notes

No special Trucks-Lkw exception: the Peugeot uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Trucks-Lkw Peugeot placard versus sidewall

If the Trucks-Lkw sticker is painted over, the handbook is next. This website is a map, not a replacement VIN label.

If the Trucks-Lkw sticker and this page disagree, the sticker wins.

Other Trucks-Lkw models

Questions about this Peugeot

What is that in bar and kPa for the Peugeot?

Mid-points are about 2.76 bar (276 kPa) front and 3.79 bar (379 kPa) rear.

What tyre pressure should a Trucks-Lkw Peugeot use?

Catalogue reference is 35-45 psi front and 45-65 psi rear (2.4-3.1 / 3.1-4.5 bar), cold. Confirm on the door-pillar placard.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

Is the sidewall number correct on a Trucks-Lkw Peugeot?

No. Sidewall PSI is a maximum. The Peugeot placard is the operating target, near 35-45/45-65 psi.

What PSI if I plus-size toward LT265/70R17?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 255/65R17, 265/70R17 and LT265/70R17 as a planning band.

Handbook: placard · bar vs PSI · front vs rear · cold inflation