UK · EU reference Tyre Pressure

Trucks-Lkw · Neoplan · Overview

Trucks-Lkw Neoplan tyre pressure

Drivetrain
front-wheel drive
Body
light commercial
PSI F / R
35-45 / 45-65
Bar F / R
2.4-3.1 / 3.1-4.5

psi

40 / 55

Catalogue mid-points, front / rear · 2.4-3.1 / 3.1-4.5 bar

35-45 psi F · 45-65 psi R · 2.4-3.1 / 3.1-4.5 bar · 276/379 kPa

On a Trucks-Lkw Neoplan the useful pair is 40 psi (2.76 bar) up front and 55 psi (3.79 bar) at the back, mid-range. TPMS typically warns near 30 psi (about 25% below target). That is already a soft tyre, not a fill target.

Temperature and a cold gauge

Roughly 1 psi per 5–6 °C. The table uses 40 psi as a 20 °C baseline for this Neoplan.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)37 psi2.55 bar255 kPaGauge reads low; do not overfill once warm
0 °C38 psi2.62 bar262 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)39 psi2.69 bar269 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)40 psi2.76 bar276 kPaBaseline
30 °C42 psi2.9 bar290 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)43 psi2.96 bar296 kPaDo not bleed a hot tyre

Spare and inflator kit

A matching full-size spare on the Trucks-Lkw Neoplan usually follows the higher axle (often the rear, near 45-65 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

PSI, bar and kPa

1 bar ≈ 14.5 psi; 1 psi ≈ 6.89 kPa. Mid-points on the Neoplan: 40 psi = 2.76 bar = 276 kPa.

PSIBarkPa
352.41241
362.48248
382.62262
402.76276
443.03303
453.10310
503.45345
553.79379
604.14414
654.48448

How to set the Neoplan

  1. Measure before the school run, not after the M25.
  2. Write LF / RF / RR / RL. Do not keep Neoplan numbers in your head.
  3. Add air in short bursts toward 40 psi (2.76 bar) front and 55 psi rear.
  4. If one corner is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Estimated pressure by tyre size (LT245/75R16 and others)

LT245/75R16 is the first planning size here. 285/70R17 is usually the plus-size or LT step. Keep load index at or above original equipment.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
LT245/75R1648673.314.62331462LT-metric, higher load
235/75R1541582.834283400Older compact truck
285/70R1744623.034.27303427Wide all-terrain
245/70R1642592.94.07290407Common 16-inch all-terrain
LT265/70R1748693.314.76331476LT 17-inch
275/65R1843612.964.21296421Plus-size 18-inch
265/70R1743602.964.14296414Typical 17-inch load tyre
255/65R1743602.964.14296414Highway 17-inch

Trucks-Lkw Neoplan placard versus sidewall

The tyre-information placard on a Trucks-Lkw Neoplan sits on the driver’s door pillar (sometimes the fuel-filler flap). Catalogue figures here are a general band: 35-45 / 45-65 psi.

Trucks-Lkw notes

No special Trucks-Lkw exception: the Neoplan uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Pressure against load

Load moves the rear of a light commercial first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only40 psi / 2.76 bar55 psi / 3.79 bar
Full occupancy41 psi / 2.83 bar57 psi / 3.93 bar
Motorway + luggage42 psi / 2.9 bar57 psi / 3.93 bar

Keep the Trucks-Lkw Neoplan on the printed band; use LT245/75R16 and 285/70R17 only as a map for non-OEM wheels.

Other Trucks-Lkw models

Questions about this Neoplan

How often should I check a Neoplan?

Monthly, before a long trip, and after a 10 °C weather swing. Include a full-size spare.

What is that in bar and kPa for the Neoplan?

Mid-points are about 2.76 bar (276 kPa) front and 3.79 bar (379 kPa) rear.

Is the sidewall number correct on a Trucks-Lkw Neoplan?

No. Sidewall PSI is a maximum. The Neoplan placard is the operating target, near 35-45/45-65 psi.

Front versus rear on the Trucks-Lkw Neoplan?

This row is 35-45 F / 45-65 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

Handbook: placard · bar vs PSI · front vs rear · cold inflation