UK · EU reference Tyre Pressure

Trucks-Lkw · LDV · Overview

Trucks-Lkw LDV tyre pressure

Drivetrain
front-wheel drive
Body
light commercial
PSI F / R
35-45 / 45-65
Bar F / R
2.4-3.1 / 3.1-4.5

psi

40 / 55

Catalogue mid-points, front / rear · 2.4-3.1 / 3.1-4.5 bar

35-45 psi F · 45-65 psi R · 2.4-3.1 / 3.1-4.5 bar · 276/379 kPa

On a Trucks-Lkw LDV the useful pair is 40 psi (2.76 bar) up front and 55 psi (3.79 bar) at the back, mid-range. Size estimates on this page include 235/75R15, 245/70R16 and 275/65R18 — interpolated from the catalogue midpoint, not a second factory sticker.

Estimated pressure by tyre size (235/75R15 and others)

235/75R15 is the first planning size here. 275/65R18 is usually the plus-size or LT step. Keep load index at or above original equipment.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
235/75R1541582.834283400Older compact truck
245/70R1642592.94.07290407Common 16-inch all-terrain
275/65R1843612.964.21296421Plus-size 18-inch
265/70R1743602.964.14296414Typical 17-inch load tyre
255/65R1743602.964.14296414Highway 17-inch
LT265/70R1748693.314.76331476LT 17-inch
LT245/75R1648673.314.62331462LT-metric, higher load
285/70R1744623.034.27303427Wide all-terrain

Spare and inflator kit

A matching full-size spare on the Trucks-Lkw LDV usually follows the higher axle (often the rear, near 45-65 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

Temperature and a cold gauge

Roughly 1 psi per 5–6 °C. The table uses 40 psi as a 20 °C baseline for this LDV.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)37 psi2.55 bar255 kPaGauge reads low; do not overfill once warm
0 °C38 psi2.62 bar262 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)39 psi2.69 bar269 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)40 psi2.76 bar276 kPaBaseline
30 °C42 psi2.9 bar290 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)43 psi2.96 bar296 kPaDo not bleed a hot tyre

How to set the LDV

  1. Measure before the school run, not after the M25.
  2. Write LF / RF / RR / RL. Do not keep LDV numbers in your head.
  3. Add air in short bursts toward 40 psi (2.76 bar) front and 55 psi rear.
  4. If one corner is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Trucks-Lkw LDV placard versus sidewall

If the Trucks-Lkw sticker is painted over, the handbook is next. This website is a map, not a replacement VIN label.

Pressure against load

Load moves the rear of a light commercial first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only40 psi / 2.76 bar55 psi / 3.79 bar
Full occupancy41 psi / 2.83 bar57 psi / 3.93 bar
Motorway + luggage42 psi / 2.9 bar59 psi / 4.07 bar

PSI, bar and kPa

1 bar ≈ 14.5 psi; 1 psi ≈ 6.89 kPa. Mid-points on the LDV: 40 psi = 2.76 bar = 276 kPa.

PSIBarkPa
352.41241
362.48248
382.62262
402.76276
443.03303
453.10310
503.45345
553.79379
604.14414
654.48448

Trucks-Lkw notes

No special Trucks-Lkw exception: the LDV uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Keep the Trucks-Lkw LDV on the printed band; use 235/75R15 and 275/65R18 only as a map for non-OEM wheels.

Other Trucks-Lkw models

Questions about this LDV

Is the sidewall number correct on a Trucks-Lkw LDV?

No. Sidewall PSI is a maximum. The LDV placard is the operating target, near 35-45/45-65 psi.

What tyre pressure should a Trucks-Lkw LDV use?

Catalogue reference is 35-45 psi front and 45-65 psi rear (2.4-3.1 / 3.1-4.5 bar), cold. Confirm on the door-pillar placard.

What is that in bar and kPa for the LDV?

Mid-points are about 2.76 bar (276 kPa) front and 3.79 bar (379 kPa) rear.

How often should I check a LDV?

Monthly, before a long trip, and after a 10 °C weather swing. Include a full-size spare.

When does TPMS warn on a Trucks-Lkw LDV?

Direct TPMS typically flags about 25% below placard — near 30 psi on this row. Fill to the sticker, not to the lamp.

Handbook: placard · bar vs PSI · front vs rear · cold inflation