UK · EU reference Tyre Pressure

Peugeot · Partner · Front

Front axle PSI and bar on the Peugeot Partner

Drivetrain
front-wheel drive
Body
light commercial
PSI F / R
35-45 / 45-65
Bar F / R
2.4-3.1 / 3.1-4.5

psi front

40

2.76 bar · 276 kPa at the steering axle

35-45 psi F · 45-65 psi R · 2.4-3.1 / 3.1-4.5 bar · 276/379 kPa

A 3 psi miss on one front corner of this Partner shows up as a wander before the TPMS lamp bothers you. Target 40 psi (2.76 bar) cold. Under-inflation cooks the shoulders of a Partner; over-inflation wears the centre rib and bangs every cat’s eye.

Peugeot Partner placard versus sidewall

The tyre-information placard on a Peugeot Partner sits on the driver’s door pillar (sometimes the fuel-filler flap). Catalogue figures here are a general band: 35-45 / 45-65 psi.

Estimated pressure by tyre size (285/70R17 and others)

285/70R17 is the first planning size here. 275/65R18 is usually the plus-size or LT step. Keep load index at or above original equipment.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
285/70R17443.03303Wide all-terrain
LT245/75R16483.31331LT-metric, higher load
275/65R18432.96296Plus-size 18-inch
LT265/70R17483.31331LT 17-inch
235/75R15412.83283Older compact truck
265/70R17432.96296Typical 17-inch load tyre
255/65R17432.96296Highway 17-inch
245/70R16422.9290Common 16-inch all-terrain

Pressure against load

Load moves the rear of a light commercial first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only40 psi / 2.76 bar55 psi / 3.79 bar
Full occupancy40 psi / 2.76 bar56 psi / 3.86 bar
Motorway + luggage41 psi / 2.83 bar59 psi / 4.07 bar

Steering feel on the Partner lives on this axle. Do not drop front pressure to “soften” a plus-size 275/65R18; you will roll the sidewall in a roundabout.

How to set the Partner

  1. Measure before the school run, not after the M25.
  2. Write LF / RF / RR / RL. Do not keep Partner numbers in your head.
  3. Add air in short bursts toward 40 psi (2.76 bar) front and 55 psi rear.
  4. If one corner is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

PSI, bar and kPa

PSI-led conversions for the Peugeot Partner band (35-45 / 45-65).

PSIBarkPa
352.41241
362.48248
382.62262
402.76276
443.03303
453.10310
503.45345
553.79379
604.14414
654.48448

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 40 psi as a 20 °C baseline for this Partner.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)37 psi2.55 bar255 kPaGauge reads low; do not overfill once warm
0 °C38 psi2.62 bar262 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)39 psi2.69 bar269 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)40 psi2.76 bar276 kPaBaseline
30 °C42 psi2.9 bar290 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)43 psi2.96 bar296 kPaDo not bleed a hot tyre

Peugeot notes

Peugeot often prints bar. A 2.4 bar 308 is about 35 psi. Do not copy a Partner van figure onto a hatchback.

Spare and inflator kit

A matching full-size spare on the Peugeot Partner usually follows the higher axle (often the rear, near 45-65 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

Keep the Peugeot Partner on the printed band; use 285/70R17 and 275/65R18 only as a map for non-OEM wheels.

Other Peugeot models

Questions about this Partner

What tyre pressure should a Peugeot Partner use?

Catalogue reference is 35-45 psi front and 45-65 psi rear (2.4-3.1 / 3.1-4.5 bar), cold. Confirm on the door-pillar placard.

How often should I check a Partner?

Monthly, before a long trip, and after a 10 °C weather swing. Include a full-size spare.

What is that in bar and kPa for the Partner?

Mid-points are about 2.76 bar (276 kPa) front and 3.79 bar (379 kPa) rear.

Front versus rear on the Peugeot Partner?

This row is 35-45 F / 45-65 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

What PSI if I plus-size toward 275/65R18?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 285/70R17, LT245/75R16 and 275/65R18 as a planning band.

Handbook: placard · bar vs PSI · front vs rear · cold inflation