UK · EU reference Tyre Pressure

Fiat · Doblo · Overview

Fiat Doblo tyre pressure

Drivetrain
front-wheel drive
Body
light commercial
PSI F / R
35-45 / 45-65
Bar F / R
2.4-3.1 / 3.1-4.5

psi

40 / 55

Catalogue mid-points, front / rear · 2.4-3.1 / 3.1-4.5 bar

35-45 psi F · 45-65 psi R · 2.4-3.1 / 3.1-4.5 bar · 276/379 kPa

The Fiat Doblo catalogue band is 35-45 psi front and 45-65 psi rear — 2.4-3.1 / 3.1-4.5 bar, or about 276 / 379 kPa — measured cold. Under-inflation cooks the shoulders of a Doblo; over-inflation wears the centre rib and bangs every cat’s eye.

PSI, bar and kPa

1 bar ≈ 14.5 psi; 1 psi ≈ 6.89 kPa. Mid-points on the Doblo: 40 psi = 2.76 bar = 276 kPa.

PSIBarkPa
352.41241
362.48248
382.62262
402.76276
443.03303
453.10310
503.45345
553.79379
604.14414
654.48448

Estimated pressure by tyre size (275/65R18 and others)

Planning cold pressures for sizes often seen on a light commercial. This Doblo sample opens with 275/65R18, then LT265/70R17 and LT245/75R16.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
275/65R1843612.964.21296421Plus-size 18-inch
LT265/70R1748693.314.76331476LT 17-inch
LT245/75R1648673.314.62331462LT-metric, higher load
245/70R1642592.94.07290407Common 16-inch all-terrain
235/75R1541582.834283400Older compact truck
255/65R1743602.964.14296414Highway 17-inch
285/70R1744623.034.27303427Wide all-terrain
265/70R1743602.964.14296414Typical 17-inch load tyre

Temperature and a cold gauge

Roughly 1 psi per 5–6 °C. The table uses 40 psi as a 20 °C baseline for this Doblo.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)37 psi2.55 bar255 kPaGauge reads low; do not overfill once warm
0 °C38 psi2.62 bar262 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)39 psi2.69 bar269 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)40 psi2.76 bar276 kPaBaseline
30 °C42 psi2.9 bar290 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)43 psi2.96 bar296 kPaDo not bleed a hot tyre

Fiat Doblo placard versus sidewall

If the Fiat sticker is painted over, the handbook is next. This website is a map, not a replacement VIN label.

Spare and inflator kit

A matching full-size spare on the Fiat Doblo usually follows the higher axle (often the rear, near 45-65 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

Fiat notes

No special Fiat exception: the Doblo uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

How to set the Doblo

  1. Measure before the school run, not after the M25.
  2. Write LF / RF / RR / RL. Do not keep Doblo numbers in your head.
  3. Add air in short bursts toward 40 psi (2.76 bar) front and 55 psi rear.
  4. If one corner is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Pressure against load

Load moves the rear of a light commercial first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only40 psi / 2.76 bar55 psi / 3.79 bar
Full occupancy41 psi / 2.83 bar57 psi / 3.93 bar
Motorway + luggage42 psi / 2.9 bar58 psi / 4 bar

A cheap gauge and a monthly habit will do more for this Doblo than nitrogen upsells.

Other Fiat models

Questions about this Doblo

What is that in bar and kPa for the Doblo?

Mid-points are about 2.76 bar (276 kPa) front and 3.79 bar (379 kPa) rear.

What PSI if I plus-size toward LT245/75R16?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 275/65R18, LT265/70R17 and LT245/75R16 as a planning band.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

How often should I check a Doblo?

Monthly, before a long trip, and after a 10 °C weather swing. Include a full-size spare.

What tyre pressure should a Fiat Doblo use?

Catalogue reference is 35-45 psi front and 45-65 psi rear (2.4-3.1 / 3.1-4.5 bar), cold. Confirm on the door-pillar placard.

Handbook: placard · bar vs PSI · front vs rear · cold inflation