UK · EU reference Tyre Pressure

Nissan · Rogue · kPa

Nissan Rogue tyre pressure in kPa

Drivetrain
front-wheel drive
Body
SUV / crossover
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

kPa

231 / 231

2.31 / 2.31 bar · 32-35 / 32-35 psi

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

If your gauge only speaks kPa, aim near 231 / 231 for this Rogue, then fine-tune to the placard. Under-inflation cooks the shoulders of a Rogue; over-inflation wears the centre rib and bangs every cat’s eye.

kPa, bar and PSI

kPa-led conversions. 220 kPa is 2.2 bar and about 32 psi — handy if this Rogue sticker uses SI units.

kPaBarPSI
2072.0730
2212.2132
2282.2833
2312.3133.5
2412.4135
2482.4836
2622.6238
2762.7640
3033.0344
3453.4550
4144.1460

Estimated pressure by tyre size (255/50R20 and others)

255/50R20 is the first planning size here. 235/65R17 is usually the plus-size or LT step. Keep load index at or above original equipment.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
255/50R2037372.552.5525525520-inch plus-size
245/60R1836372.482.55248255Heavier CUV
235/65R1735362.412.48241248Mid-size SUV
235/60R1836362.482.48248248Plus-size 18-inch
225/60R1835352.412.41241241Highway CUV
225/65R1735352.412.41241241Very common 17-inch
245/55R1936362.482.48248248Low-profile 19-inch
215/70R1634342.342.34234234Compact crossover

Nissan Rogue placard versus sidewall

If the Nissan sticker is painted over, the handbook is next. This website is a map, not a replacement VIN label.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this Rogue.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

How to set the Rogue

  1. Measure before the school run, not after the M25.
  2. Write LF / RF / RR / RL. Do not keep Rogue numbers in your head.
  3. Add air in short bursts toward 34 psi (2.31 bar) front and 34 psi rear.
  4. If one corner is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Load notes

Load moves the rear of a SUV / crossover first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy35 psi / 2.41 bar36 psi / 2.48 bar
Motorway + luggage36 psi / 2.48 bar36 psi / 2.48 bar

Nissan notes

A Qashqai and a Navara do not share a number. Vans and taxis may sit higher than a family hatch.

Spare and inflator kit

A matching full-size spare on the Nissan Rogue usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

If the Nissan sticker and this page disagree, the sticker wins.

Other Nissan models

Questions about this Rogue

What is that in bar and kPa for the Rogue?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

How often should I check a Rogue?

Monthly, before a long trip, and after a 10 °C weather swing. Include a full-size spare.

What PSI if I plus-size toward 235/65R17?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 255/50R20, 245/60R18 and 235/65R17 as a planning band.

What tyre pressure should a Nissan Rogue use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

Handbook: placard · bar vs PSI · front vs rear · cold inflation