UK · EU reference Tyre Pressure

Land Rover · Series · PSI

Land Rover Series tyre PSI

Drivetrain
four-wheel drive
Body
passenger car
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

psi

34 / 34

Catalogue mid-points, front / rear · 2.2-2.4 / 2.2-2.4 bar

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

If a Series owner asks “what PSI?”, start at 34 at the steering axle and 34 at the rear, then confirm the placard. TPMS typically warns near 25 psi (about 25% below target). That is already a soft tyre, not a fill target. Keep side-to-side spread inside about 2 psi so the four-wheel drive hardware is not working on a radius mismatch.

Land Rover Series placard versus sidewall

The tyre-information placard on a Land Rover Series sits on the driver’s door pillar (sometimes the fuel-filler flap). Catalogue figures here are a general band: 32-35 / 32-35 psi.

PSI, bar and kPa

PSI-led conversions for the Land Rover Series band (32-35 / 32-35).

PSIBarkPa
302.07207
322.21221
332.28228
33.52.31231
352.41241
362.48248
382.62262
402.76276
443.03303
503.45345
604.14414

Estimated pressure by tyre size (205/55R16 and others)

Planning cold pressures for sizes often seen on a passenger car. This Series sample opens with 205/55R16, then 245/40R18 and 185/65R15.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
205/55R1634342.342.34234234Typical mid-compact OEM
245/40R1836362.482.48248248Wide touring 18-inch
185/65R1533332.282.28228228Small / older car
205/60R1634342.342.34234234Taller 16-inch
225/45R1735352.412.41241241Sport 17-inch
215/50R1735352.412.41241241Plus-size 17-inch
215/55R1634352.342.41234241Slightly wider 16-inch
225/50R1735352.412.41241241Touring 17-inch

How to set the Series

  1. Park the Land Rover Series for at least three hours (cold tyres).
  2. Use a calibrated gauge, not the only meter on a forecourt hose.
  3. Set the placard for that axle — about 32-35 psi / 2.2-2.4 bar front and 32-35 psi / 2.2-2.4 bar rear on this catalogue row.
  4. Recheck all four. A 2 psi miss on a four-wheel drive Series is enough to feel a pull.
  5. Refit valve caps and reset TPMS if the handbook asks for a relearn.

Load notes

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy34 psi / 2.34 bar35 psi / 2.41 bar
Motorway + luggage35 psi / 2.41 bar37 psi / 2.55 bar

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this Series.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

Land Rover notes

Land Rover 4x4s may list terrain programmes. Highway pressure is still the placard; airing down off-road is temporary.

Spare and inflator kit

A matching full-size spare on the Land Rover Series usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

If the Land Rover sticker and this page disagree, the sticker wins.

Other Land Rover models

Questions about this Series

Front versus rear on the Land Rover Series?

This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

Is the sidewall number correct on a Land Rover Series?

No. Sidewall PSI is a maximum. The Series placard is the operating target, near 32-35/32-35 psi.

When does TPMS warn on a Land Rover Series?

Direct TPMS typically flags about 25% below placard — near 25 psi on this row. Fill to the sticker, not to the lamp.

What is that in bar and kPa for the Series?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

Handbook: placard · bar vs PSI · front vs rear · cold inflation