UK · EU reference Tyre Pressure

Land Rover · Series · Overview

Land Rover Series tyre pressure

Drivetrain
four-wheel drive
Body
passenger car
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

psi

34 / 34

Catalogue mid-points, front / rear · 2.2-2.4 / 2.2-2.4 bar

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

On a Land Rover Series the useful pair is 34 psi (2.31 bar) up front and 34 psi (2.31 bar) at the back, mid-range. TPMS typically warns near 25 psi (about 25% below target). That is already a soft tyre, not a fill target. Keep side-to-side spread inside about 2 psi so the four-wheel drive hardware is not working on a radius mismatch.

Land Rover notes

Land Rover 4x4s may list terrain programmes. Highway pressure is still the placard; airing down off-road is temporary.

Spare and inflator kit

A matching full-size spare on the Land Rover Series usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

PSI, bar and kPa

1 bar ≈ 14.5 psi; 1 psi ≈ 6.89 kPa. Mid-points on the Series: 34 psi = 2.31 bar = 231 kPa.

PSIBarkPa
302.07207
322.21221
332.28228
33.52.31231
352.41241
362.48248
382.62262
402.76276
443.03303
503.45345
604.14414

Pressure against load

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy34 psi / 2.34 bar35 psi / 2.41 bar
Motorway + luggage35 psi / 2.41 bar36 psi / 2.48 bar

How to set the Series

  1. Park the Land Rover Series for at least three hours (cold tyres).
  2. Use a calibrated gauge, not the only meter on a forecourt hose.
  3. Set the placard for that axle — about 32-35 psi / 2.2-2.4 bar front and 32-35 psi / 2.2-2.4 bar rear on this catalogue row.
  4. Recheck all four. A 2 psi miss on a four-wheel drive Series is enough to feel a pull.
  5. Refit valve caps and reset TPMS if the handbook asks for a relearn.

Land Rover Series placard versus sidewall

Sidewall PSI is a carcass maximum. Recommended operating pressure for this Series is the pillar sticker, near 34/34 psi.

Temperature and a cold gauge

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this Series.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

Estimated pressure by tyre size (185/65R15 and others)

Planning cold pressures for sizes often seen on a passenger car. This Series sample opens with 185/65R15, then 225/50R17 and 195/65R15.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
185/65R1533332.282.28228228Small / older car
225/50R1735352.412.41241241Touring 17-inch
195/65R1534342.342.34234234Very common compact
205/55R1634342.342.34234234Typical mid-compact OEM
225/40R1836362.482.48248248Low-profile 18-inch
215/55R1634352.342.41234241Slightly wider 16-inch
225/45R1735352.412.41241241Sport 17-inch
205/60R1634342.342.34234234Taller 16-inch

A cheap gauge and a monthly habit will do more for this Series than nitrogen upsells.

Other Land Rover models

Questions about this Series

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

What tyre pressure should a Land Rover Series use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

Is the sidewall number correct on a Land Rover Series?

No. Sidewall PSI is a maximum. The Series placard is the operating target, near 32-35/32-35 psi.

When does TPMS warn on a Land Rover Series?

Direct TPMS typically flags about 25% below placard — near 25 psi on this row. Fill to the sticker, not to the lamp.

What is that in bar and kPa for the Series?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

Handbook: placard · bar vs PSI · front vs rear · cold inflation