UK · EU reference Tyre Pressure

245/40R18 · passenger car · PSI

245/40R18 tyre pressure in PSI

Size
245/40R18
Class
passenger car
Planning PSI
36
Planning bar
2.48

psi

36

2.48 bar · 248 kPa · passenger car planning figure

245/40R18 · 36 psi · 2.48 bar · 248 kPa — estimates. Placard wins.

PSI is the garage-hose number. For 245/40R18 a typical passenger car planning figure is 36 psi cold — about 2.48 bar or 248 kPa. TPMS typically warns near 27 psi (about 25% below a 36 psi target). That is already a soft tyre. Low-profile {sz} does not want a “softer” pressure to recover ride. Stay at or slightly above the car’s original placard if load index is kept.

Estimated 245/40R18 pressure by load

Plus-sizing to 245/40R18 from a taller OEM tyre usually keeps the same placard if the load index is equal or higher.

ConditionFront (est.)Rear (est.)
Driver only / unladen36 psi / 2.48 bar / 248 kPa36 psi / 2.48 bar / 248 kPa
Typical occupancy36 psi / 2.48 bar / 248 kPa37 psi / 2.55 bar / 255 kPa
Motorway + luggage (sketch)37 psi / 2.55 bar / 255 kPa38 psi / 2.62 bar / 262 kPa

PSI, bar and kPa

Convert around the 245/40R18 band. 2.48 bar is about 36 psi — not 23, not 33 unless the maths says so.

PSIBarkPa
322.21221
332.28228
342.34234
352.41241
362.48248
372.55255
382.62262
392.69269
402.76276
412.83283
422.90290
432.96296
443.03303
453.10310
463.17317
473.24324
483.31331

What 245/40R18 means

245/40R18 means a 245 millimetre section width, a sidewall that is 40 percent of that width, on a 18-inch rim. The R is radial construction.

Wide touring 18-inch. Rim diameter 18 in; section 245 mm. Estimates on this page assume a typical load index for the passenger car class.

Placard versus sidewall

If a forum says “all 245/40R18 run 36 psi”, ignore it. A Qashqai and a Golf can share a size and not share a sticker.

Cars often seen on 245/40R18

These catalogue models are often seen on 245/40R18 or a close OEM neighbour. Open the vehicle chart for axle-specific PSI and bar.

How to set 245/40R18

  1. Park so the 245/40R18 tyres are cold (three hours, or less than about a mile).
  2. Read the door-pillar placard for that car — not the 245/40R18 sidewall maximum.
  3. If the sticker is missing, 36 psi / 2.48 bar is only a passenger car planning figure for this size.
  4. Set all four with a calibrated gauge. A 3 psi miss on one corner shows up as a wander.
  5. Refit valve caps and reset TPMS if the handbook asks for a relearn.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 36 psi as a 20 °C baseline for 245/40R18.

AmbientGaugeBarkPaNote
−5 °C (hard frost)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
0 °C34 psi2.34 bar234 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)35 psi2.41 bar241 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)36 psi2.48 bar248 kPaBaseline for this size sketch
30 °C38 psi2.62 bar262 kPaDo not bleed a hot 245/40R18
38 °C (heatwave tarmac)39 psi2.69 bar269 kPaDo not bleed a hot 245/40R18

If the door sticker and this 245/40R18 page disagree, the sticker wins.

Questions about 245/40R18

What PSI should 245/40R18 tyres be?

A passenger car planning figure is about 36 psi cold (2.48 bar / 248 kPa). Confirm on the vehicle placard — two cars can share 245/40R18 and not share a sticker.

Can I run 245/40R18 at a lower pressure for comfort?

Not as a habit. A soft 245/40R18 cooks the shoulders and dulls steering. Keep load index and stay on the placard.

When does TPMS warn on 245/40R18?

Direct TPMS typically flags about 25% below target — near 27 psi if you were aiming at 36. Fill to the sticker, not to the lamp.

What is 245/40R18 in bar?

36 psi is 2.48 bar. Add a tenth of a bar if the placard’s laden column is higher, which is common on vans that wear this size.

Is the sidewall number correct for 245/40R18?

No. Sidewall PSI or kPa is a maximum for the carcass. Operating pressure is the door-pillar placard.

Handbook: placard · bar vs PSI · cold inflation · all sizes