Ford · F 150 · kPa
Ford F 150 kPa inflation table
- Drivetrain
- rear-wheel drive
- Body
- pickup / double-cab
- PSI F / R
- 32-35 / 32-35
- Bar F / R
- 2.2-2.4 / 2.2-2.4
kPa
231 / 231
2.31 / 2.31 bar · 32-35 / 32-35 psi
32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa
If your gauge only speaks kPa, aim near 231 / 231 for this F 150, then fine-tune to the placard. Under-inflation cooks the shoulders of a F 150; over-inflation wears the centre rib and bangs every cat’s eye. Commercial and load-biased bodies like this pickup / double-cab often need a higher rear; LT or C-type sizes such as LT245/75R16 are not filled like a Fiesta.
kPa, bar and PSI
kPa-led conversions. 220 kPa is 2.2 bar and about 32 psi — handy if this F 150 sticker uses SI units.
| kPa | Bar | PSI |
|---|---|---|
| 207 | 2.07 | 30 |
| 221 | 2.21 | 32 |
| 228 | 2.28 | 33 |
| 231 | 2.31 | 33.5 |
| 241 | 2.41 | 35 |
| 248 | 2.48 | 36 |
| 262 | 2.62 | 38 |
| 276 | 2.76 | 40 |
| 303 | 3.03 | 44 |
| 345 | 3.45 | 50 |
| 414 | 4.14 | 60 |
Estimated pressure by tyre size (255/65R17 and others)
Planning cold pressures for sizes often seen on a pickup / double-cab. This F 150 sample opens with 255/65R17, then 285/70R17 and LT245/75R16.
| Tyre size | Front PSI | Rear PSI | Front bar | Rear bar | Front kPa | Rear kPa | Note |
|---|---|---|---|---|---|---|---|
| 255/65R17 | 37 | 39 | 2.55 | 2.69 | 255 | 269 | Highway 17-inch |
| 285/70R17 | 38 | 41 | 2.62 | 2.83 | 262 | 283 | Wide all-terrain |
| LT245/75R16 | 42 | 46 | 2.9 | 3.17 | 290 | 317 | LT-metric, higher load |
| LT265/70R17 | 42 | 48 | 2.9 | 3.31 | 290 | 331 | LT 17-inch |
| 245/70R16 | 36 | 38 | 2.48 | 2.62 | 248 | 262 | Common 16-inch all-terrain |
| 275/65R18 | 37 | 40 | 2.55 | 2.76 | 255 | 276 | Plus-size 18-inch |
| 265/70R17 | 37 | 39 | 2.55 | 2.69 | 255 | 269 | Typical 17-inch load tyre |
| 235/75R15 | 35 | 37 | 2.41 | 2.55 | 241 | 255 | Older compact truck |
Ford F 150 placard versus sidewall
Sidewall PSI is a carcass maximum. Recommended operating pressure for this F 150 is the pillar sticker, near 34/34 psi.
Temperature drift
Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this F 150.
| Ambient | Gauge (front mid) | Bar | kPa | Note |
|---|---|---|---|---|
| −5 °C (hard frost) | 31 psi | 2.14 bar | 214 kPa | Gauge reads low; do not overfill once warm |
| 0 °C | 32 psi | 2.21 bar | 221 kPa | Gauge reads low; do not overfill once warm |
| 8 °C (UK winter morning) | 33 psi | 2.28 bar | 228 kPa | Gauge reads low; do not overfill once warm |
| 20 °C (set cold here) | 34 psi | 2.34 bar | 234 kPa | Baseline |
| 30 °C | 36 psi | 2.48 bar | 248 kPa | Do not bleed a hot tyre |
| 38 °C (heatwave tarmac) | 37 psi | 2.55 bar | 255 kPa | Do not bleed a hot tyre |
How to set the F 150
- Park the Ford F 150 for at least three hours (cold tyres).
- Use a calibrated gauge, not the only meter on a forecourt hose.
- Set the placard for that axle — about 32-35 psi / 2.2-2.4 bar front and 32-35 psi / 2.2-2.4 bar rear on this catalogue row.
- Recheck all four. A 2 psi miss on a rear-wheel drive F 150 is enough to feel a pull.
- Refit valve caps and reset TPMS if the handbook asks for a relearn.
Load notes
Load moves the rear of a pickup / double-cab first. If the factory placard already has a “laden” column, use that instead of these sketches.
| Condition | Front (est.) | Rear (est.) |
|---|---|---|
| Driver only | 34 psi / 2.34 bar | 34 psi / 2.34 bar |
| Full occupancy | 34 psi / 2.34 bar | 35 psi / 2.41 bar |
| Payload / towing | 35 psi / 2.41 bar | 38 psi / 2.62 bar |
Ford notes
Ford UK placards on the F 150 are often printed in PSI even when the handbook also shows bar. A Mondeo, Focus or Kuga does not share a Transit number. Loaded vans use the second column.
Spare and inflator kit
A matching full-size spare on the Ford F 150 usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.
If the Ford sticker and this page disagree, the sticker wins.
Other Ford models
Questions about this F 150
What PSI if I plus-size toward LT245/75R16?
Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 255/65R17, 285/70R17 and LT245/75R16 as a planning band.
Front versus rear on the Ford F 150?
This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.
Should I bleed pressure after a motorway run?
No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.
How often should I check a F 150?
Monthly, before a long trip, and after a 10 °C weather swing. Include a full-size spare.
Is the sidewall number correct on a Ford F 150?
No. Sidewall PSI is a maximum. The F 150 placard is the operating target, near 32-35/32-35 psi.
Handbook: placard · bar vs PSI · front vs rear · cold inflation