UK · EU reference Tyre Pressure

235/75R15 · pickup / double-cab · kPa

241 kPa for 235/75R15 tyres

Size
235/75R15
Class
pickup / double-cab
Planning PSI
35
Planning bar
2.41

kPa

241

2.41 bar · 35 psi · 100 kPa = 1 bar

235/75R15 · 35 psi · 2.41 bar · 241 kPa — estimates. Placard wins.

Kilopascals show up on some Asian stickers and ISO sheets. 241 kPa is the planning midpoint for 235/75R15 (2.41 bar / 35 psi). 100 kPa = 1 bar. TPMS typically warns near 26 psi (about 25% below a 35 psi target). That is already a soft tyre.

kPa, bar and PSI

1 bar ≈ 14.5 psi; 1 psi ≈ 6.89 kPa. Planning midpoint for 235/75R15: 35 psi = 2.41 bar = 241 kPa.

kPaBarPSI
2142.1431
2212.2132
2282.2833
2342.3434
2412.4135
2482.4836
2552.5537
2622.6238
2692.6939
2762.7640
2832.8341
2902.9042
2962.9643
3033.0344
3103.1045
3173.1746
3243.2447

Estimated 235/75R15 pressure by load

Load moves the rear first on a pickup / double-cab. If the factory placard already has a laden column, use that — not this sketch for 235/75R15.

ConditionFront (est.)Rear (est.)
Driver only / unladen35 psi / 2.41 bar / 241 kPa37 psi / 2.55 bar / 255 kPa
Typical occupancy36 psi / 2.48 bar / 248 kPa39 psi / 2.69 bar / 269 kPa
Payload / towing (sketch)37 psi / 2.55 bar / 255 kPa40 psi / 2.76 bar / 276 kPa

What 235/75R15 means

Read 235/75R15 as width / aspect R rim. Nothing in the size string is a pressure. Pressure lives on the car, not moulded as 205 or 55.

Older compact truck. Rim diameter 15 in; section 235 mm. Estimates on this page assume a typical load index for the pickup / double-cab class.

Placard versus sidewall

This website maps size searches such as “235/75R15 psi”. It does not replace the VIN label. If the two disagree, the label wins.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 35 psi as a 20 °C baseline for 235/75R15.

AmbientGaugeBarkPaNote
−5 °C (hard frost)32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
0 °C33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)34 psi2.34 bar234 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)35 psi2.41 bar241 kPaBaseline for this size sketch
30 °C37 psi2.55 bar255 kPaDo not bleed a hot 235/75R15
38 °C (heatwave tarmac)38 psi2.62 bar262 kPaDo not bleed a hot 235/75R15

How to set 235/75R15

  1. Measure before the school run, not after the motorway.
  2. Write LF / RF / RR / RL. Do not keep 235/75R15 numbers in your head.
  3. Add air in short bursts toward the placard, using 35 psi only as a map.
  4. If one 235/75R15 is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Cars often seen on 235/75R15

These catalogue models are often seen on 235/75R15 or a close OEM neighbour. Open the vehicle chart for axle-specific PSI and bar.

A cheap gauge and a monthly habit will do more for a set of 235/75R15 than nitrogen upsells.

Questions about 235/75R15

What PSI should 235/75R15 tyres be?

A pickup / double-cab planning figure is about 35 psi cold (2.41 bar / 241 kPa). Confirm on the vehicle placard — two cars can share 235/75R15 and not share a sticker.

What is 235/75R15 in kPa?

241 kPa is the planning midpoint (100 kPa = 1 bar). 248 kPa is one PSI higher.

Can I run 235/75R15 at a lower pressure for comfort?

Not as a habit. A soft 235/75R15 cooks the shoulders and dulls steering. Keep load index and stay on the placard.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

Is the sidewall number correct for 235/75R15?

No. Sidewall PSI or kPa is a maximum for the carcass. Operating pressure is the door-pillar placard.

Handbook: placard · bar vs PSI · cold inflation · all sizes