UK · EU reference Tyre Pressure

LT265/70R17 · LT-metric truck · kPa

379 kPa for LT265/70R17 tyres

Size
LT265/70R17
Class
LT-metric truck
Planning PSI
55
Planning bar
3.79

kPa

379

3.79 bar · 55 psi · 100 kPa = 1 bar

LT265/70R17 · 55 psi · 3.79 bar · 379 kPa — estimates. Placard wins.

If the gauge only speaks kPa, 379 kPa is the sketch for this LT-metric truck size. Fine-tune to the vehicle that actually wears LT265/70R17. A 10 °C overnight drop takes roughly 1 psi (0.07 bar) off a closed LT265/70R17. LT-metric sizes print a load range. The vehicle door sticker, not the LT sidewall maximum, is still the operating pressure.

kPa, bar and PSI

Use the table, then set a cold gauge. 379 kPa is 100 × 3.79 bar on this size.

kPaBarPSI
3033.0344
3173.1746
3453.4550
3523.5251
3593.5952
3653.6553
3723.7254
3793.7955
3863.8656
3933.9357
4004.0058
4074.0759
4144.1460
4214.2161
4274.2762
4344.3463
4414.4164
4484.4865
4554.5566
4624.6267
5525.5280

Estimated LT265/70R17 pressure by load

These LT265/70R17 load steps are ± a few PSI from 55. They are not a licence to ignore a printed second column on a van or estate.

ConditionFront (est.)Rear (est.)
Driver only / unladen55 psi / 3.79 bar / 379 kPa58 psi / 4 bar / 400 kPa
Typical occupancy56 psi / 3.86 bar / 386 kPa60 psi / 4.14 bar / 414 kPa
Payload / towing (sketch)57 psi / 3.93 bar / 393 kPa67 psi / 4.62 bar / 462 kPa

What LT265/70R17 means

LT265/70R17 means a 265 millimetre section width, a sidewall that is 70 percent of that width, on a 17-inch rim. The R is radial construction.

Typical LT 17-inch. Rim diameter 17 in; section 265 mm. Estimates on this page assume a typical load index for the LT-metric truck class.

Placard versus sidewall

If a forum says “all LT265/70R17 run 55 psi”, ignore it. A Qashqai and a Golf can share a size and not share a sticker.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 55 psi as a 20 °C baseline for LT265/70R17.

AmbientGaugeBarkPaNote
−5 °C (hard frost)52 psi3.59 bar359 kPaGauge reads low; do not overfill once warm
0 °C53 psi3.65 bar365 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)54 psi3.72 bar372 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)55 psi3.79 bar379 kPaBaseline for this size sketch
30 °C57 psi3.93 bar393 kPaDo not bleed a hot LT265/70R17
38 °C (heatwave tarmac)58 psi4 bar400 kPaDo not bleed a hot LT265/70R17

How to set LT265/70R17

  1. Park so the LT265/70R17 tyres are cold (three hours, or less than about a mile).
  2. Read the door-pillar placard for that car — not the LT265/70R17 sidewall maximum.
  3. If the sticker is missing, 55 psi / 3.79 bar is only a LT-metric truck planning figure for this size.
  4. Set all four with a calibrated gauge. A 3 psi miss on one corner shows up as a wander.
  5. Refit valve caps and reset TPMS if the handbook asks for a relearn.

Cars often seen on LT265/70R17

These catalogue models are often seen on LT265/70R17 or a close OEM neighbour. Open the vehicle chart for axle-specific PSI and bar.

A cheap gauge and a monthly habit will do more for a set of LT265/70R17 than nitrogen upsells.

Questions about LT265/70R17

What is LT265/70R17 in kPa?

379 kPa is the planning midpoint (100 kPa = 1 bar). 386 kPa is one PSI higher.

Is LT265/70R17 the same as a plus-size swap?

Only if that is the size you fitted. Overall diameter should stay close to OEM. Pressure still follows the car, with load index at or above original.

What PSI should LT265/70R17 tyres be?

A LT-metric truck planning figure is about 55 psi cold (3.79 bar / 379 kPa). Confirm on the vehicle placard — two cars can share LT265/70R17 and not share a sticker.

Can I run LT265/70R17 at a lower pressure for comfort?

Not as a habit. A soft LT265/70R17 cooks the shoulders and dulls steering. Keep load index and stay on the placard.

When does TPMS warn on LT265/70R17?

Direct TPMS typically flags about 25% below target — near 41 psi if you were aiming at 55. Fill to the sticker, not to the lamp.

Handbook: placard · bar vs PSI · cold inflation · all sizes