Trucks-Lkw · Zettelmeyer · Bar
Trucks-Lkw Zettelmeyer bar chart (2.4-3.1 / 3.1-4.5)
- Drivetrain
- front-wheel drive
- Body
- light commercial
- PSI F / R
- 35-45 / 45-65
- Bar F / R
- 2.4-3.1 / 3.1-4.5
bar
2.76 / 3.79
35-45 / 45-65 psi · 276 / 379 kPa
35-45 psi F · 45-65 psi R · 2.4-3.1 / 3.1-4.5 bar · 276/379 kPa
A front-wheel drive Trucks-Lkw Zettelmeyer still wants even corners. 2.4-3.1 vs 3.1-4.5 is an axle split, not a left-right split. Under-inflation cooks the shoulders of a Zettelmeyer; over-inflation wears the centre rib and bangs every cat’s eye.
Bar, PSI and kPa
Bar-led conversions around the Trucks-Lkw Zettelmeyer. 2.4-3.1 bar is not “35-45 divided by ten”.
| Bar | PSI | kPa |
|---|---|---|
| 2.41 | 35 | 241 |
| 2.48 | 36 | 248 |
| 2.62 | 38 | 262 |
| 2.76 | 40 | 276 |
| 3.03 | 44 | 303 |
| 3.10 | 45 | 310 |
| 3.45 | 50 | 345 |
| 3.79 | 55 | 379 |
| 4.14 | 60 | 414 |
| 4.48 | 65 | 448 |
Trucks-Lkw Zettelmeyer placard versus sidewall
Sidewall PSI is a carcass maximum. Recommended operating pressure for this Zettelmeyer is the pillar sticker, near 40/55 psi.
Estimated pressure by tyre size (245/70R16 and others)
If your Trucks-Lkw Zettelmeyer no longer wears the OEM diameter, start at the row nearest 245/70R16 or 235/75R15 and confirm with the tyre maker’s load table.
| Tyre size | Front PSI | Rear PSI | Front bar | Rear bar | Front kPa | Rear kPa | Note |
|---|---|---|---|---|---|---|---|
| 245/70R16 | 42 | 59 | 2.9 | 4.07 | 290 | 407 | Common 16-inch all-terrain |
| 235/75R15 | 41 | 58 | 2.83 | 4 | 283 | 400 | Older compact truck |
| LT245/75R16 | 48 | 67 | 3.31 | 4.62 | 331 | 462 | LT-metric, higher load |
| 265/70R17 | 43 | 60 | 2.96 | 4.14 | 296 | 414 | Typical 17-inch load tyre |
| LT265/70R17 | 48 | 69 | 3.31 | 4.76 | 331 | 476 | LT 17-inch |
| 285/70R17 | 44 | 62 | 3.03 | 4.27 | 303 | 427 | Wide all-terrain |
| 255/65R17 | 43 | 60 | 2.96 | 4.14 | 296 | 414 | Highway 17-inch |
| 275/65R18 | 43 | 61 | 2.96 | 4.21 | 296 | 421 | Plus-size 18-inch |
Load notes
Load moves the rear of a light commercial first. If the factory placard already has a “laden” column, use that instead of these sketches.
| Condition | Front (est.) | Rear (est.) |
|---|---|---|
| Driver only | 40 psi / 2.76 bar | 55 psi / 3.79 bar |
| Full occupancy | 40 psi / 2.76 bar | 56 psi / 3.86 bar |
| Motorway + luggage | 41 psi / 2.83 bar | 58 psi / 4 bar |
How to set the Zettelmeyer
- Park the Trucks-Lkw Zettelmeyer for at least three hours (cold tyres).
- Use a calibrated gauge, not the only meter on a forecourt hose.
- Set the placard for that axle — about 35-45 psi / 2.4-3.1 bar front and 45-65 psi / 3.1-4.5 bar rear on this catalogue row.
- Recheck all four. A 2 psi miss on a front-wheel drive Zettelmeyer is enough to feel a pull.
- Refit valve caps and reset TPMS if the handbook asks for a relearn.
Temperature drift
Roughly 1 psi per 5–6 °C. The table uses 40 psi as a 20 °C baseline for this Zettelmeyer.
| Ambient | Gauge (front mid) | Bar | kPa | Note |
|---|---|---|---|---|
| −5 °C (hard frost) | 37 psi | 2.55 bar | 255 kPa | Gauge reads low; do not overfill once warm |
| 0 °C | 38 psi | 2.62 bar | 262 kPa | Gauge reads low; do not overfill once warm |
| 8 °C (UK winter morning) | 39 psi | 2.69 bar | 269 kPa | Gauge reads low; do not overfill once warm |
| 20 °C (set cold here) | 40 psi | 2.76 bar | 276 kPa | Baseline |
| 30 °C | 42 psi | 2.9 bar | 290 kPa | Do not bleed a hot tyre |
| 38 °C (heatwave tarmac) | 43 psi | 2.96 bar | 296 kPa | Do not bleed a hot tyre |
Trucks-Lkw notes
No special Trucks-Lkw exception: the Zettelmeyer uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.
Spare and inflator kit
A matching full-size spare on the Trucks-Lkw Zettelmeyer usually follows the higher axle (often the rear, near 45-65 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.
Keep the Trucks-Lkw Zettelmeyer on the printed band; use 245/70R16 and LT245/75R16 only as a map for non-OEM wheels.
Other Trucks-Lkw models
Questions about this Zettelmeyer
Is the sidewall number correct on a Trucks-Lkw Zettelmeyer?
No. Sidewall PSI is a maximum. The Zettelmeyer placard is the operating target, near 35-45/45-65 psi.
How often should I check a Zettelmeyer?
Monthly, before a long trip, and after a 10 °C weather swing. Include a full-size spare.
What tyre pressure should a Trucks-Lkw Zettelmeyer use?
Catalogue reference is 35-45 psi front and 45-65 psi rear (2.4-3.1 / 3.1-4.5 bar), cold. Confirm on the door-pillar placard.
Should I bleed pressure after a motorway run?
No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.
When does TPMS warn on a Trucks-Lkw Zettelmeyer?
Direct TPMS typically flags about 25% below placard — near 30 psi on this row. Fill to the sticker, not to the lamp.
Handbook: placard · bar vs PSI · front vs rear · cold inflation