UK · EU reference Tyre Pressure

Mitsubishi · Space Wagon · Front

Mitsubishi Space Wagon front tyre pressure

Drivetrain
front-wheel drive
Body
passenger car
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

psi front

34

2.31 bar · 231 kPa at the steering axle

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

The front axle of a Mitsubishi Space Wagon steers and, on front-wheel drive cars, often pulls as well. Catalogue front pressure is 32-35 psi / 2.2-2.4 bar. Size estimates on this page include 185/65R15, 215/50R17 and 215/55R16 — interpolated from the catalogue midpoint, not a second factory sticker.

Mitsubishi Space Wagon placard versus sidewall

If the Mitsubishi sticker is painted over, the handbook is next. This website is a map, not a replacement VIN label.

Estimated pressure by tyre size (185/65R15 and others)

Planning cold pressures for sizes often seen on a passenger car. This Space Wagon sample opens with 185/65R15, then 215/50R17 and 215/55R16.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
185/65R15332.28228Small / older car
215/50R17352.41241Plus-size 17-inch
215/55R16342.34234Slightly wider 16-inch
195/65R15342.34234Very common compact
245/40R18362.48248Wide touring 18-inch
225/50R17352.41241Touring 17-inch
205/60R16342.34234Taller 16-inch
225/45R17352.41241Sport 17-inch

Pressure against load

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy35 psi / 2.41 bar36 psi / 2.48 bar
Motorway + luggage36 psi / 2.48 bar37 psi / 2.55 bar

Steering feel on the Space Wagon lives on this axle. Do not drop front pressure to “soften” a plus-size 215/55R16; you will roll the sidewall in a roundabout.

How to set the Space Wagon

  1. Park the Mitsubishi Space Wagon for at least three hours (cold tyres).
  2. Use a calibrated gauge, not the only meter on a forecourt hose.
  3. Set the placard for that axle — about 32-35 psi / 2.2-2.4 bar front and 32-35 psi / 2.2-2.4 bar rear on this catalogue row.
  4. Recheck all four. A 2 psi miss on a front-wheel drive Space Wagon is enough to feel a pull.
  5. Refit valve caps and reset TPMS if the handbook asks for a relearn.

PSI, bar and kPa

PSI-led conversions for the Mitsubishi Space Wagon band (32-35 / 32-35).

PSIBarkPa
302.07207
322.21221
332.28228
33.52.31231
352.41241
362.48248
382.62262
402.76276
443.03303
503.45345
604.14414

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this Space Wagon.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

Mitsubishi notes

No special Mitsubishi exception: the Space Wagon uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the Mitsubishi Space Wagon usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

If the Mitsubishi sticker and this page disagree, the sticker wins.

Other Mitsubishi models

Questions about this Space Wagon

What is that in bar and kPa for the Space Wagon?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

When does TPMS warn on a Mitsubishi Space Wagon?

Direct TPMS typically flags about 25% below placard — near 25 psi on this row. Fill to the sticker, not to the lamp.

How often should I check a Space Wagon?

Monthly, before a long trip, and after a 10 °C weather swing. Include a full-size spare.

What tyre pressure should a Mitsubishi Space Wagon use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

Is the sidewall number correct on a Mitsubishi Space Wagon?

No. Sidewall PSI is a maximum. The Space Wagon placard is the operating target, near 32-35/32-35 psi.

Handbook: placard · bar vs PSI · front vs rear · cold inflation