UK · EU reference Tyre Pressure

MINI · John Cooper Works Paceman · Cold

Cold tyre pressure for a MINI John Cooper Works Paceman

Drivetrain
front-wheel drive
Body
passenger car
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

psi

34 / 34

Catalogue mid-points, front / rear · 2.2-2.4 / 2.2-2.4 bar

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

Cold means the MINI John Cooper Works Paceman has stood at least three hours, or covered less than about a mile. Heat from a dual carriageway run is not the number you set. TPMS typically warns near 25 psi (about 25% below target). That is already a soft tyre, not a fill target.

Temperature and a cold gauge

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this John Cooper Works Paceman.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

How to set the John Cooper Works Paceman

  1. Measure before the school run, not after the M25.
  2. Write LF / RF / RR / RL. Do not keep John Cooper Works Paceman numbers in your head.
  3. Add air in short bursts toward 34 psi (2.31 bar) front and 34 psi rear.
  4. If one corner is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

MINI John Cooper Works Paceman placard versus sidewall

The tyre-information placard on a MINI John Cooper Works Paceman sits on the driver’s door pillar (sometimes the fuel-filler flap). Catalogue figures here are a general band: 32-35 / 32-35 psi.

Estimated pressure by tyre size (205/55R16 and others)

205/55R16 is the first planning size here. 225/40R18 is usually the plus-size or LT step. Keep load index at or above original equipment.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
205/55R1634342.342.34234234Typical mid-compact OEM
225/45R1735352.412.41241241Sport 17-inch
225/40R1836362.482.48248248Low-profile 18-inch
205/60R1634342.342.34234234Taller 16-inch
245/40R1836362.482.48248248Wide touring 18-inch
225/50R1735352.412.41241241Touring 17-inch
195/65R1534342.342.34234234Very common compact
215/50R1735352.412.41241241Plus-size 17-inch

PSI, bar and kPa

PSI-led conversions for the MINI John Cooper Works Paceman band (32-35 / 32-35).

PSIBarkPa
302.07207
322.21221
332.28228
33.52.31231
352.41241
362.48248
382.62262
402.76276
443.03303
503.45345
604.14414

Load notes

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy35 psi / 2.41 bar36 psi / 2.48 bar
Motorway + luggage36 psi / 2.48 bar37 psi / 2.55 bar

MINI notes

MINI run-flats ride harshly if you overshoot. Stay in the printed band on this John Cooper Works Paceman.

Spare and inflator kit

A matching full-size spare on the MINI John Cooper Works Paceman usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

Keep the MINI John Cooper Works Paceman on the printed band; use 205/55R16 and 225/40R18 only as a map for non-OEM wheels.

Other MINI models

Questions about this John Cooper Works Paceman

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

When does TPMS warn on a MINI John Cooper Works Paceman?

Direct TPMS typically flags about 25% below placard — near 25 psi on this row. Fill to the sticker, not to the lamp.

How often should I check a John Cooper Works Paceman?

Monthly, before a long trip, and after a 10 °C weather swing. Include a full-size spare.

What is that in bar and kPa for the John Cooper Works Paceman?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

What tyre pressure should a MINI John Cooper Works Paceman use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

Handbook: placard · bar vs PSI · front vs rear · cold inflation