UK · EU reference Tyre Pressure

Mercedes-Benz · E 36 AMG · PSI

Mercedes-Benz E 36 AMG tyre PSI

Drivetrain
rear-wheel drive
Body
passenger car
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

psi

34 / 34

Catalogue mid-points, front / rear · 2.2-2.4 / 2.2-2.4 bar

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

If a E 36 AMG owner asks “what PSI?”, start at 34 at the steering axle and 34 at the rear, then confirm the placard. Size estimates on this page include 275/35R18, 225/40R18 and 245/40R18 — interpolated from the catalogue midpoint, not a second factory sticker.

Mercedes-Benz E 36 AMG placard versus sidewall

The tyre-information placard on a Mercedes-Benz E 36 AMG sits on the driver’s door pillar (sometimes the fuel-filler flap). Catalogue figures here are a general band: 32-35 / 32-35 psi.

PSI, bar and kPa

PSI-led conversions for the Mercedes-Benz E 36 AMG band (32-35 / 32-35).

PSIBarkPa
302.07207
322.21221
332.28228
33.52.31231
352.41241
362.48248
382.62262
402.76276
443.03303
503.45345
604.14414

Estimated pressure by tyre size (275/35R18 and others)

Planning cold pressures for sizes often seen on a passenger car. This E 36 AMG sample opens with 275/35R18, then 225/40R18 and 245/40R18.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
275/35R1836372.482.55248255Wide rear
225/40R1835352.412.41241241Front 18-inch
245/40R1835362.412.48241248Square-ish sport
235/35R1936362.482.48248248Front 19-inch
225/45R1734352.342.41234241Front sport size
255/35R1835362.412.48241248Rear stagger 18-inch
255/40R1735362.412.48241248Rear stagger 17-inch
275/30R1936372.482.55248255Rear 19-inch

How to set the E 36 AMG

  1. Measure before the school run, not after the M25.
  2. Write LF / RF / RR / RL. Do not keep E 36 AMG numbers in your head.
  3. Add air in short bursts toward 34 psi (2.31 bar) front and 34 psi rear.
  4. If one corner is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Load notes

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy34 psi / 2.34 bar35 psi / 2.41 bar
Motorway + luggage35 psi / 2.41 bar37 psi / 2.55 bar

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this E 36 AMG.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

Mercedes-Benz notes

Mercedes often lists comfort versus load. Match the table to how the E 36 AMG is actually occupied that day.

Spare and inflator kit

A matching full-size spare on the Mercedes-Benz E 36 AMG usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

If the Mercedes-Benz sticker and this page disagree, the sticker wins.

Other Mercedes-Benz models

Questions about this E 36 AMG

Front versus rear on the Mercedes-Benz E 36 AMG?

This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

What is that in bar and kPa for the E 36 AMG?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

What tyre pressure should a Mercedes-Benz E 36 AMG use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

What PSI if I plus-size toward 245/40R18?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 275/35R18, 225/40R18 and 245/40R18 as a planning band.

Handbook: placard · bar vs PSI · front vs rear · cold inflation