UK · EU reference Tyre Pressure

235/35R19 · passenger car · PSI

235/35R19 PSI chart (37 psi planning figure)

Size
235/35R19
Class
passenger car
Planning PSI
37
Planning bar
2.55

psi

37

2.55 bar · 255 kPa · passenger car planning figure

235/35R19 · 37 psi · 2.55 bar · 255 kPa — estimates. Placard wins.

PSI is the garage-hose number. For 235/35R19 a typical passenger car planning figure is 37 psi cold — about 2.55 bar or 255 kPa. TPMS typically warns near 28 psi (about 25% below a 37 psi target). That is already a soft tyre. Low-profile {sz} does not want a “softer” pressure to recover ride. Stay at or slightly above the car’s original placard if load index is kept.

Estimated 235/35R19 pressure by load

Plus-sizing to 235/35R19 from a taller OEM tyre usually keeps the same placard if the load index is equal or higher.

ConditionFront (est.)Rear (est.)
Driver only / unladen37 psi / 2.55 bar / 255 kPa37 psi / 2.55 bar / 255 kPa
Typical occupancy37 psi / 2.55 bar / 255 kPa38 psi / 2.62 bar / 262 kPa
Motorway + luggage (sketch)38 psi / 2.62 bar / 262 kPa39 psi / 2.69 bar / 269 kPa

PSI, bar and kPa

1 bar ≈ 14.5 psi; 1 psi ≈ 6.89 kPa. Planning midpoint for 235/35R19: 37 psi = 2.55 bar = 255 kPa.

PSIBarkPa
332.28228
342.34234
352.41241
362.48248
372.55255
382.62262
392.69269
402.76276
412.83283
422.90290
432.96296
443.03303
453.10310
463.17317
473.24324
483.31331
493.38338

What 235/35R19 means

A 235/35R19 on a passenger car is a geometry. Two cars can share the size and disagree on PSI because mass and axle split differ.

Front 19-inch sport / EV. Rim diameter 19 in; section 235 mm. Estimates on this page assume a typical load index for the passenger car class.

Placard versus sidewall

This website maps size searches such as “235/35R19 psi”. It does not replace the VIN label. If the two disagree, the label wins.

Cars often seen on 235/35R19

These catalogue models are often seen on 235/35R19 or a close OEM neighbour. Open the vehicle chart for axle-specific PSI and bar.

How to set 235/35R19

  1. Measure before the school run, not after the motorway.
  2. Write LF / RF / RR / RL. Do not keep 235/35R19 numbers in your head.
  3. Add air in short bursts toward the placard, using 37 psi only as a map.
  4. If one 235/35R19 is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 37 psi as a 20 °C baseline for 235/35R19.

AmbientGaugeBarkPaNote
−5 °C (hard frost)34 psi2.34 bar234 kPaGauge reads low; do not overfill once warm
0 °C35 psi2.41 bar241 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)36 psi2.48 bar248 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)37 psi2.55 bar255 kPaBaseline for this size sketch
30 °C39 psi2.69 bar269 kPaDo not bleed a hot 235/35R19
38 °C (heatwave tarmac)40 psi2.76 bar276 kPaDo not bleed a hot 235/35R19

If the door sticker and this 235/35R19 page disagree, the sticker wins.

Questions about 235/35R19

Is the sidewall number correct for 235/35R19?

No. Sidewall PSI or kPa is a maximum for the carcass. Operating pressure is the door-pillar placard.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

What is 235/35R19 in bar?

37 psi is 2.55 bar. Add a tenth of a bar if the placard’s laden column is higher, which is common on vans that wear this size.

Can I run 235/35R19 at a lower pressure for comfort?

Not as a habit. A soft 235/35R19 cooks the shoulders and dulls steering. Keep load index and stay on the placard.

When does TPMS warn on 235/35R19?

Direct TPMS typically flags about 25% below target — near 28 psi if you were aiming at 37. Fill to the sticker, not to the lamp.

Handbook: placard · bar vs PSI · cold inflation · all sizes