UK · EU reference Tyre Pressure

Mercedes-Benz · CL 65 AMG · Overview

Mercedes-Benz CL 65 AMG: 2.2-2.4 bar / 32-35 psi

Drivetrain
rear-wheel drive
Body
passenger car
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

psi

34 / 34

Catalogue mid-points, front / rear · 2.2-2.4 / 2.2-2.4 bar

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

This rear-wheel drive passenger car is filed here with a working range of 32-35/32-35 psi. The pillar sticker on your VIN still overrides the website. Under-inflation cooks the shoulders of a CL 65 AMG; over-inflation wears the centre rib and bangs every cat’s eye.

Spare and inflator kit

A matching full-size spare on the Mercedes-Benz CL 65 AMG usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

Mercedes-Benz notes

Mercedes often lists comfort versus load. Match the table to how the CL 65 AMG is actually occupied that day.

How to set the CL 65 AMG

  1. Measure before the school run, not after the M25.
  2. Write LF / RF / RR / RL. Do not keep CL 65 AMG numbers in your head.
  3. Add air in short bursts toward 34 psi (2.31 bar) front and 34 psi rear.
  4. If one corner is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Temperature and a cold gauge

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this CL 65 AMG.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

PSI, bar and kPa

1 bar ≈ 14.5 psi; 1 psi ≈ 6.89 kPa. Mid-points on the CL 65 AMG: 34 psi = 2.31 bar = 231 kPa.

PSIBarkPa
302.07207
322.21221
332.28228
33.52.31231
352.41241
362.48248
382.62262
402.76276
443.03303
503.45345
604.14414

Mercedes-Benz CL 65 AMG placard versus sidewall

Sidewall PSI is a carcass maximum. Recommended operating pressure for this CL 65 AMG is the pillar sticker, near 34/34 psi.

Estimated pressure by tyre size (245/40R18 and others)

Planning cold pressures for sizes often seen on a passenger car. This CL 65 AMG sample opens with 245/40R18, then 275/30R19 and 225/45R17.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
245/40R1835362.412.48241248Square-ish sport
275/30R1936372.482.55248255Rear 19-inch
225/45R1734352.342.41234241Front sport size
225/40R1835352.412.41241241Front 18-inch
255/35R1835362.412.48241248Rear stagger 18-inch
255/40R1735362.412.48241248Rear stagger 17-inch
235/35R1936362.482.48248248Front 19-inch
275/35R1836372.482.55248255Wide rear

Pressure against load

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy34 psi / 2.34 bar35 psi / 2.41 bar
Motorway + luggage35 psi / 2.41 bar38 psi / 2.62 bar

Keep the Mercedes-Benz CL 65 AMG on the printed band; use 245/40R18 and 225/45R17 only as a map for non-OEM wheels.

Other Mercedes-Benz models

Questions about this CL 65 AMG

Front versus rear on the Mercedes-Benz CL 65 AMG?

This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

What tyre pressure should a Mercedes-Benz CL 65 AMG use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

When does TPMS warn on a Mercedes-Benz CL 65 AMG?

Direct TPMS typically flags about 25% below placard — near 25 psi on this row. Fill to the sticker, not to the lamp.

What is that in bar and kPa for the CL 65 AMG?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

What PSI if I plus-size toward 225/45R17?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 245/40R18, 275/30R19 and 225/45R17 as a planning band.

Handbook: placard · bar vs PSI · front vs rear · cold inflation