UK · EU reference Tyre Pressure

LT285/70R17 · LT-metric truck · kPa

LT285/70R17 tyre pressure in kPa

Size
LT285/70R17
Class
LT-metric truck
Planning PSI
56
Planning bar
3.86

kPa

386

3.86 bar · 56 psi · 100 kPa = 1 bar

LT285/70R17 · 56 psi · 3.86 bar · 386 kPa — estimates. Placard wins.

Kilopascals show up on some Asian stickers and ISO sheets. 386 kPa is the planning midpoint for LT285/70R17 (3.86 bar / 56 psi). 100 kPa = 1 bar. Wide all-terrain LT. These rows are estimates interpolated for the size, not OEM for a named VIN. LT-metric sizes print a load range. The vehicle door sticker, not the LT sidewall maximum, is still the operating pressure.

kPa, bar and PSI

Use the table, then set a cold gauge. 386 kPa is 100 × 3.86 bar on this size.

kPaBarPSI
3033.0344
3173.1746
3453.4550
3593.5952
3653.6553
3723.7254
3793.7955
3863.8656
3933.9357
4004.0058
4074.0759
4144.1460
4214.2161
4274.2762
4344.3463
4414.4164
4484.4865
4554.5566
4624.6267
4694.6968
5525.5280

Estimated LT285/70R17 pressure by load

These LT285/70R17 load steps are ± a few PSI from 56. They are not a licence to ignore a printed second column on a van or estate.

ConditionFront (est.)Rear (est.)
Driver only / unladen56 psi / 3.86 bar / 386 kPa58 psi / 4 bar / 400 kPa
Typical occupancy56 psi / 3.86 bar / 386 kPa59 psi / 4.07 bar / 407 kPa
Payload / towing (sketch)57 psi / 3.93 bar / 393 kPa66 psi / 4.55 bar / 455 kPa

What LT285/70R17 means

Read LT285/70R17 as width / aspect R rim. Nothing in the size string is a pressure. Pressure lives on the car, not moulded as 205 or 55.

Wide all-terrain LT. Rim diameter 17 in; section 285 mm. Estimates on this page assume a typical load index for the LT-metric truck class.

Placard versus sidewall

This website maps size searches such as “LT285/70R17 psi”. It does not replace the VIN label. If the two disagree, the label wins.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 56 psi as a 20 °C baseline for LT285/70R17.

AmbientGaugeBarkPaNote
−5 °C (hard frost)53 psi3.65 bar365 kPaGauge reads low; do not overfill once warm
0 °C54 psi3.72 bar372 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)55 psi3.79 bar379 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)56 psi3.86 bar386 kPaBaseline for this size sketch
30 °C58 psi4 bar400 kPaDo not bleed a hot LT285/70R17
38 °C (heatwave tarmac)59 psi4.07 bar407 kPaDo not bleed a hot LT285/70R17

How to set LT285/70R17

  1. Measure before the school run, not after the motorway.
  2. Write LF / RF / RR / RL. Do not keep LT285/70R17 numbers in your head.
  3. Add air in short bursts toward the placard, using 56 psi only as a map.
  4. If one LT285/70R17 is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Cars often seen on LT285/70R17

These catalogue models are often seen on LT285/70R17 or a close OEM neighbour. Open the vehicle chart for axle-specific PSI and bar.

If the door sticker and this LT285/70R17 page disagree, the sticker wins.

Questions about LT285/70R17

What PSI should LT285/70R17 tyres be?

A LT-metric truck planning figure is about 56 psi cold (3.86 bar / 386 kPa). Confirm on the vehicle placard — two cars can share LT285/70R17 and not share a sticker.

Can I run LT285/70R17 at a lower pressure for comfort?

Not as a habit. A soft LT285/70R17 cooks the shoulders and dulls steering. Keep load index and stay on the placard.

What is LT285/70R17 in bar?

56 psi is 3.86 bar. Add a tenth of a bar if the placard’s laden column is higher, which is common on vans that wear this size.

When does TPMS warn on LT285/70R17?

Direct TPMS typically flags about 25% below target — near 42 psi if you were aiming at 56. Fill to the sticker, not to the lamp.

Is the sidewall number correct for LT285/70R17?

No. Sidewall PSI or kPa is a maximum for the carcass. Operating pressure is the door-pillar placard.

Handbook: placard · bar vs PSI · cold inflation · all sizes