UK · EU reference Tyre Pressure

255/70R16 · pickup / double-cab · kPa

241 kPa for 255/70R16 tyres

Size
255/70R16
Class
pickup / double-cab
Planning PSI
35
Planning bar
2.41

kPa

241

2.41 bar · 35 psi · 100 kPa = 1 bar

255/70R16 · 35 psi · 2.41 bar · 241 kPa — estimates. Placard wins.

If the gauge only speaks kPa, 241 kPa is the sketch for this pickup / double-cab size. Fine-tune to the vehicle that actually wears 255/70R16. Under-inflation cooks the shoulders of a 255/70R16; over-inflation wears the centre rib and bangs every cat’s eye.

kPa, bar and PSI

Convert around the 255/70R16 band. 2.41 bar is about 35 psi — not 23, not 33 unless the maths says so.

kPaBarPSI
2142.1431
2212.2132
2282.2833
2342.3434
2412.4135
2482.4836
2552.5537
2622.6238
2692.6939
2762.7640
2832.8341
2902.9042
2962.9643
3033.0344
3103.1045
3173.1746
3243.2447

Estimated 255/70R16 pressure by load

Load moves the rear first on a pickup / double-cab. If the factory placard already has a laden column, use that — not this sketch for 255/70R16.

ConditionFront (est.)Rear (est.)
Driver only / unladen35 psi / 2.41 bar / 241 kPa39 psi / 2.69 bar / 269 kPa
Typical occupancy35 psi / 2.41 bar / 241 kPa40 psi / 2.76 bar / 276 kPa
Payload / towing (sketch)36 psi / 2.48 bar / 248 kPa41 psi / 2.83 bar / 283 kPa

What 255/70R16 means

255/70R16 means a 255 millimetre section width, a sidewall that is 70 percent of that width, on a 16-inch rim. The R is radial construction.

16-inch crossover-truck overlap. Rim diameter 16 in; section 255 mm. Estimates on this page assume a typical load index for the pickup / double-cab class.

Placard versus sidewall

The sidewall of a 255/70R16 may say 51 psi or 350 kPa. That is a carcass maximum. Operating pressure is the tyre-information placard on the driver’s door pillar.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 35 psi as a 20 °C baseline for 255/70R16.

AmbientGaugeBarkPaNote
−5 °C (hard frost)32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
0 °C33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)34 psi2.34 bar234 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)35 psi2.41 bar241 kPaBaseline for this size sketch
30 °C37 psi2.55 bar255 kPaDo not bleed a hot 255/70R16
38 °C (heatwave tarmac)38 psi2.62 bar262 kPaDo not bleed a hot 255/70R16

How to set 255/70R16

  1. Measure before the school run, not after the motorway.
  2. Write LF / RF / RR / RL. Do not keep 255/70R16 numbers in your head.
  3. Add air in short bursts toward the placard, using 35 psi only as a map.
  4. If one 255/70R16 is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Cars often seen on 255/70R16

These catalogue models are often seen on 255/70R16 or a close OEM neighbour. Open the vehicle chart for axle-specific PSI and bar.

If the door sticker and this 255/70R16 page disagree, the sticker wins.

Questions about 255/70R16

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

Can I run 255/70R16 at a lower pressure for comfort?

Not as a habit. A soft 255/70R16 cooks the shoulders and dulls steering. Keep load index and stay on the placard.

Is the sidewall number correct for 255/70R16?

No. Sidewall PSI or kPa is a maximum for the carcass. Operating pressure is the door-pillar placard.

What PSI should 255/70R16 tyres be?

A pickup / double-cab planning figure is about 35 psi cold (2.41 bar / 241 kPa). Confirm on the vehicle placard — two cars can share 255/70R16 and not share a sticker.

What is 255/70R16 in bar?

35 psi is 2.41 bar. Add a tenth of a bar if the placard’s laden column is higher, which is common on vans that wear this size.

Handbook: placard · bar vs PSI · cold inflation · all sizes