Livan · X3 Pro · kPa

231 kPa front, 231 kPa rear — Livan X3 Pro

Drivetrain: front-wheel drive
Body: SUV / crossover
PSI F / R: 32-35 / 32-35
Bar F / R: 2.2-2.4 / 2.2-2.4

kPa

231 / 231

2.31 / 2.31 bar · 32-35 / 32-35 psi

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

Kilopascals show up on some Asian stickers and ISO sheets. 231 kPa front and 231 kPa rear is the Livan X3 Pro midpoint (100 kPa = 1 bar). TPMS typically warns near 25 psi (about 25% below target). That is already a soft tyre, not a fill target.

kPa, bar and PSI

kPa-led conversions. 220 kPa is 2.2 bar and about 32 psi — handy if this X3 Pro sticker uses SI units.

kPa	Bar	PSI
207	2.07	30
221	2.21	32
228	2.28	33
231	2.31	33.5
241	2.41	35
248	2.48	36
262	2.62	38
276	2.76	40
303	3.03	44
345	3.45	50
414	4.14	60

Estimated pressure by tyre size (235/65R17 and others)

235/65R17 is the first planning size here. 255/50R20 is usually the plus-size or LT step. Keep load index at or above original equipment.

Tyre size	Front PSI	Rear PSI	Front bar	Rear bar	Front kPa	Rear kPa	Note
235/65R17	35	36	2.41	2.48	241	248	Mid-size SUV
225/65R17	35	35	2.41	2.41	241	241	Very common 17-inch
255/50R20	37	37	2.55	2.55	255	255	20-inch plus-size
245/60R18	36	37	2.48	2.55	248	255	Heavier CUV
225/60R18	35	35	2.41	2.41	241	241	Highway CUV
215/70R16	34	34	2.34	2.34	234	234	Compact crossover
245/55R19	36	36	2.48	2.48	248	248	Low-profile 19-inch
235/60R18	36	36	2.48	2.48	248	248	Plus-size 18-inch

Livan X3 Pro placard versus sidewall

If the Livan sticker is painted over, the handbook is next. This website is a map, not a replacement VIN label.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this X3 Pro.

Ambient	Gauge (front mid)	Bar	kPa	Note
−5 °C (hard frost)	31 psi	2.14 bar	214 kPa	Gauge reads low; do not overfill once warm
0 °C	32 psi	2.21 bar	221 kPa	Gauge reads low; do not overfill once warm
8 °C (UK winter morning)	33 psi	2.28 bar	228 kPa	Gauge reads low; do not overfill once warm
20 °C (set cold here)	34 psi	2.34 bar	234 kPa	Baseline
30 °C	36 psi	2.48 bar	248 kPa	Do not bleed a hot tyre
38 °C (heatwave tarmac)	37 psi	2.55 bar	255 kPa	Do not bleed a hot tyre

How to set the X3 Pro

Measure before the school run, not after the M25.
Write LF / RF / RR / RL. Do not keep X3 Pro numbers in your head.
Add air in short bursts toward 34 psi (2.31 bar) front and 34 psi rear.
If one corner is 4 psi down, hunt for a nail before you blame the weather.
Log date, ambient temperature and the four readings.

Load notes

Load moves the rear of a SUV / crossover first. If the factory placard already has a “laden” column, use that instead of these sketches.

Condition	Front (est.)	Rear (est.)
Driver only	34 psi / 2.34 bar	34 psi / 2.34 bar
Full occupancy	34 psi / 2.34 bar	35 psi / 2.41 bar
Motorway + luggage	35 psi / 2.41 bar	38 psi / 2.62 bar

Livan notes

No special Livan exception: the X3 Pro uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the Livan X3 Pro usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

If the Livan sticker and this page disagree, the sticker wins.

Other Livan models

Questions about this X3 Pro

Front versus rear on the Livan X3 Pro?

This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

When does TPMS warn on a Livan X3 Pro?

Direct TPMS typically flags about 25% below placard — near 25 psi on this row. Fill to the sticker, not to the lamp.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

What PSI if I plus-size toward 255/50R20?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 235/65R17, 225/65R17 and 255/50R20 as a planning band.

What is that in bar and kPa for the X3 Pro?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

Handbook: placard · bar vs PSI · front vs rear · cold inflation