Giotti Victoria · Gladiator · Bar
Giotti Victoria Gladiator bar chart (2.2-2.4 / 2.2-2.4)
- Drivetrain
- rear-wheel drive
- Body
- pickup / double-cab
- PSI F / R
- 32-35 / 32-35
- Bar F / R
- 2.2-2.4 / 2.2-2.4
bar
2.31 / 2.31
32-35 / 32-35 psi · 231 / 231 kPa
32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa
European and UK handbooks usually quote bar. The Giotti Victoria Gladiator catalogue is 2.2-2.4 bar front and 2.2-2.4 bar rear (midpoint 2.31 / 2.31). Under-inflation cooks the shoulders of a Gladiator; over-inflation wears the centre rib and bangs every cat’s eye. Commercial and load-biased bodies like this pickup / double-cab often need a higher rear; LT or C-type sizes such as LT265/70R17 are not filled like a Fiesta.
Bar, PSI and kPa
Bar-led conversions around the Giotti Victoria Gladiator. 2.2-2.4 bar is not “32-35 divided by ten”.
| Bar | PSI | kPa |
|---|---|---|
| 2.07 | 30 | 207 |
| 2.21 | 32 | 221 |
| 2.28 | 33 | 228 |
| 2.31 | 33.5 | 231 |
| 2.41 | 35 | 241 |
| 2.48 | 36 | 248 |
| 2.62 | 38 | 262 |
| 2.76 | 40 | 276 |
| 3.03 | 44 | 303 |
| 3.45 | 50 | 345 |
| 4.14 | 60 | 414 |
Giotti Victoria Gladiator placard versus sidewall
The tyre-information placard on a Giotti Victoria Gladiator sits on the driver’s door pillar (sometimes the fuel-filler flap). Catalogue figures here are a general band: 32-35 / 32-35 psi.
Estimated pressure by tyre size (255/65R17 and others)
Planning cold pressures for sizes often seen on a pickup / double-cab. This Gladiator sample opens with 255/65R17, then 245/70R16 and LT265/70R17.
| Tyre size | Front PSI | Rear PSI | Front bar | Rear bar | Front kPa | Rear kPa | Note |
|---|---|---|---|---|---|---|---|
| 255/65R17 | 37 | 39 | 2.55 | 2.69 | 255 | 269 | Highway 17-inch |
| 245/70R16 | 36 | 38 | 2.48 | 2.62 | 248 | 262 | Common 16-inch all-terrain |
| LT265/70R17 | 42 | 48 | 2.9 | 3.31 | 290 | 331 | LT 17-inch |
| 285/70R17 | 38 | 41 | 2.62 | 2.83 | 262 | 283 | Wide all-terrain |
| 265/70R17 | 37 | 39 | 2.55 | 2.69 | 255 | 269 | Typical 17-inch load tyre |
| LT245/75R16 | 42 | 46 | 2.9 | 3.17 | 290 | 317 | LT-metric, higher load |
| 275/65R18 | 37 | 40 | 2.55 | 2.76 | 255 | 276 | Plus-size 18-inch |
| 235/75R15 | 35 | 37 | 2.41 | 2.55 | 241 | 255 | Older compact truck |
Load notes
Load moves the rear of a pickup / double-cab first. If the factory placard already has a “laden” column, use that instead of these sketches.
| Condition | Front (est.) | Rear (est.) |
|---|---|---|
| Driver only | 34 psi / 2.34 bar | 34 psi / 2.34 bar |
| Full occupancy | 34 psi / 2.34 bar | 35 psi / 2.41 bar |
| Payload / towing | 35 psi / 2.41 bar | 37 psi / 2.55 bar |
How to set the Gladiator
- Park the Giotti Victoria Gladiator for at least three hours (cold tyres).
- Use a calibrated gauge, not the only meter on a forecourt hose.
- Set the placard for that axle — about 32-35 psi / 2.2-2.4 bar front and 32-35 psi / 2.2-2.4 bar rear on this catalogue row.
- Recheck all four. A 2 psi miss on a rear-wheel drive Gladiator is enough to feel a pull.
- Refit valve caps and reset TPMS if the handbook asks for a relearn.
Temperature drift
Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this Gladiator.
| Ambient | Gauge (front mid) | Bar | kPa | Note |
|---|---|---|---|---|
| −5 °C (hard frost) | 31 psi | 2.14 bar | 214 kPa | Gauge reads low; do not overfill once warm |
| 0 °C | 32 psi | 2.21 bar | 221 kPa | Gauge reads low; do not overfill once warm |
| 8 °C (UK winter morning) | 33 psi | 2.28 bar | 228 kPa | Gauge reads low; do not overfill once warm |
| 20 °C (set cold here) | 34 psi | 2.34 bar | 234 kPa | Baseline |
| 30 °C | 36 psi | 2.48 bar | 248 kPa | Do not bleed a hot tyre |
| 38 °C (heatwave tarmac) | 37 psi | 2.55 bar | 255 kPa | Do not bleed a hot tyre |
Giotti Victoria notes
No special Giotti Victoria exception: the Gladiator uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.
Spare and inflator kit
A matching full-size spare on the Giotti Victoria Gladiator usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.
Keep the Giotti Victoria Gladiator on the printed band; use 255/65R17 and LT265/70R17 only as a map for non-OEM wheels.
Other Giotti Victoria models
Questions about this Gladiator
When does TPMS warn on a Giotti Victoria Gladiator?
Direct TPMS typically flags about 25% below placard — near 25 psi on this row. Fill to the sticker, not to the lamp.
Is the sidewall number correct on a Giotti Victoria Gladiator?
No. Sidewall PSI is a maximum. The Gladiator placard is the operating target, near 32-35/32-35 psi.
What tyre pressure should a Giotti Victoria Gladiator use?
Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.
How often should I check a Gladiator?
Monthly, before a long trip, and after a 10 °C weather swing. Include a full-size spare.
Should I bleed pressure after a motorway run?
No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.
Handbook: placard · bar vs PSI · front vs rear · cold inflation