UK · EU reference Tyre Pressure

Elaris · Lenn · Recommended

Elaris Lenn recommended cold inflation

Drivetrain
front-wheel drive
Body
passenger car
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

psi

34 / 34

Catalogue mid-points, front / rear · 2.2-2.4 / 2.2-2.4 bar

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

Recommended pressure means the vehicle placard, not the tyre sidewall. For a Elaris Lenn the catalogue proxy is 32-35/32-35 psi (2.2-2.4/2.2-2.4 bar). Size estimates on this page include 195/65R15, 215/55R16 and 245/40R18 — interpolated from the catalogue midpoint, not a second factory sticker.

How to set the Lenn

  1. Measure before the school run, not after the M25.
  2. Write LF / RF / RR / RL. Do not keep Lenn numbers in your head.
  3. Add air in short bursts toward 34 psi (2.31 bar) front and 34 psi rear.
  4. If one corner is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Elaris Lenn placard versus sidewall

The tyre-information placard on a Elaris Lenn sits on the driver’s door pillar (sometimes the fuel-filler flap). Catalogue figures here are a general band: 32-35 / 32-35 psi.

Estimated pressure by tyre size (195/65R15 and others)

If your Elaris Lenn no longer wears the OEM diameter, start at the row nearest 195/65R15 or 215/55R16 and confirm with the tyre maker’s load table.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
195/65R1534342.342.34234234Very common compact
215/55R1634352.342.41234241Slightly wider 16-inch
245/40R1836362.482.48248248Wide touring 18-inch
215/50R1735352.412.41241241Plus-size 17-inch
185/65R1533332.282.28228228Small / older car
205/60R1634342.342.34234234Taller 16-inch
225/40R1836362.482.48248248Low-profile 18-inch
205/55R1634342.342.34234234Typical mid-compact OEM

PSI, bar and kPa

PSI-led conversions for the Elaris Lenn band (32-35 / 32-35).

PSIBarkPa
302.07207
322.21221
332.28228
33.52.31231
352.41241
362.48248
382.62262
402.76276
443.03303
503.45345
604.14414

Pressure against load

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy35 psi / 2.41 bar36 psi / 2.48 bar
Motorway + luggage36 psi / 2.48 bar36 psi / 2.48 bar

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this Lenn.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

Elaris notes

No special Elaris exception: the Lenn uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the Elaris Lenn usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

If the Elaris sticker and this page disagree, the sticker wins.

Other Elaris models

Questions about this Lenn

What is that in bar and kPa for the Lenn?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

How often should I check a Lenn?

Monthly, before a long trip, and after a 10 °C weather swing. Include a full-size spare.

When does TPMS warn on a Elaris Lenn?

Direct TPMS typically flags about 25% below placard — near 25 psi on this row. Fill to the sticker, not to the lamp.

What tyre pressure should a Elaris Lenn use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

Handbook: placard · bar vs PSI · front vs rear · cold inflation