UK · EU reference Tyre Pressure

Elaris · Lenn · Rear

Elaris Lenn rear tyre pressure

Drivetrain
front-wheel drive
Body
passenger car
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

psi rear

34

2.31 bar · 231 kPa at the rear axle

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

The rear of a passenger car takes passengers, luggage and, on vans, payload. Catalogue rear pressure on the Elaris Lenn is 32-35 psi / 2.2-2.4 bar. TPMS typically warns near 25 psi (about 25% below target). That is already a soft tyre, not a fill target.

Elaris Lenn placard versus sidewall

If the Elaris sticker is painted over, the handbook is next. This website is a map, not a replacement VIN label.

Estimated pressure by tyre size (195/65R15 and others)

If your Elaris Lenn no longer wears the OEM diameter, start at the row nearest 195/65R15 or 205/60R16 and confirm with the tyre maker’s load table.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
195/65R15342.34234Very common compact
205/60R16342.34234Taller 16-inch
245/40R18362.48248Wide touring 18-inch
225/45R17352.41241Sport 17-inch
215/55R16352.41241Slightly wider 16-inch
225/40R18362.48248Low-profile 18-inch
215/50R17352.41241Plus-size 17-inch
205/55R16342.34234Typical mid-compact OEM

Pressure against load

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy35 psi / 2.41 bar36 psi / 2.48 bar
Motorway + luggage36 psi / 2.48 bar37 psi / 2.55 bar

A family passenger car with a boot full of luggage should use the laden rear figure if Ford, VW or Mercedes printed one. Otherwise the modest steps in the load table are only a sketch for this Lenn.

How to set the Lenn

  1. Measure before the school run, not after the M25.
  2. Write LF / RF / RR / RL. Do not keep Lenn numbers in your head.
  3. Add air in short bursts toward 34 psi (2.31 bar) front and 34 psi rear.
  4. If one corner is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

PSI, bar and kPa

PSI-led conversions for the Elaris Lenn band (32-35 / 32-35).

PSIBarkPa
302.07207
322.21221
332.28228
33.52.31231
352.41241
362.48248
382.62262
402.76276
443.03303
503.45345
604.14414

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this Lenn.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

Elaris notes

No special Elaris exception: the Lenn uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the Elaris Lenn usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

If the Elaris sticker and this page disagree, the sticker wins.

Other Elaris models

Questions about this Lenn

Front versus rear on the Elaris Lenn?

This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

When does TPMS warn on a Elaris Lenn?

Direct TPMS typically flags about 25% below placard — near 25 psi on this row. Fill to the sticker, not to the lamp.

Is the sidewall number correct on a Elaris Lenn?

No. Sidewall PSI is a maximum. The Lenn placard is the operating target, near 32-35/32-35 psi.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

What is that in bar and kPa for the Lenn?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

Handbook: placard · bar vs PSI · front vs rear · cold inflation