UK · EU reference Tyre Pressure

Dangel · Boxer · Recommended

Dangel Boxer recommended cold inflation

Drivetrain
front-wheel drive
Body
van
PSI F / R
35-45 / 45-65
Bar F / R
2.4-3.1 / 3.1-4.5

psi

40 / 55

Catalogue mid-points, front / rear · 2.4-3.1 / 3.1-4.5 bar

35-45 psi F · 45-65 psi R · 2.4-3.1 / 3.1-4.5 bar · 276/379 kPa

Treat this page as a map of the Boxer band. The legal setpoint is the printed door-pillar label for your VIN. Under-inflation cooks the shoulders of a Boxer; over-inflation wears the centre rib and bangs every cat’s eye. Commercial and load-biased bodies like this van often need a higher rear; LT or C-type sizes such as 235/65R16 are not filled like a Fiesta.

How to set the Boxer

  1. Measure before the school run, not after the M25.
  2. Write LF / RF / RR / RL. Do not keep Boxer numbers in your head.
  3. Add air in short bursts toward 40 psi (2.76 bar) front and 55 psi rear.
  4. If one corner is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Dangel Boxer placard versus sidewall

If the Dangel sticker is painted over, the handbook is next. This website is a map, not a replacement VIN label.

Estimated pressure by tyre size (215/75R16C and others)

215/75R16C is the first planning size here. 235/65R16 is usually the plus-size or LT step. Keep load index at or above original equipment.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
215/75R16C45643.14.41310441C-type 215
LT215/85R1646653.174.48317448LT commercial
235/65R1642592.94.07290407Loaded van
225/75R1642602.94.14290414Taller load range
225/65R1641582.834283400Common transaxle van
215/65R1640572.763.93276393Compact van
235/60R1741582.834283400Plus-size van
195/75R16C44633.034.34303434C-type commercial

PSI, bar and kPa

PSI-led conversions for the Dangel Boxer band (35-45 / 45-65).

PSIBarkPa
352.41241
362.48248
382.62262
402.76276
443.03303
453.10310
503.45345
553.79379
604.14414
654.48448

Pressure against load

Load moves the rear of a van first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only40 psi / 2.76 bar55 psi / 3.79 bar
Full occupancy41 psi / 2.83 bar57 psi / 3.93 bar
Payload / towing42 psi / 2.9 bar59 psi / 4.07 bar

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 40 psi as a 20 °C baseline for this Boxer.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)37 psi2.55 bar255 kPaGauge reads low; do not overfill once warm
0 °C38 psi2.62 bar262 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)39 psi2.69 bar269 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)40 psi2.76 bar276 kPaBaseline
30 °C42 psi2.9 bar290 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)43 psi2.96 bar296 kPaDo not bleed a hot tyre

Dangel notes

No special Dangel exception: the Boxer uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the Dangel Boxer usually follows the higher axle (often the rear, near 45-65 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

A cheap gauge and a monthly habit will do more for this Boxer than nitrogen upsells.

Other Dangel models

Questions about this Boxer

Is the sidewall number correct on a Dangel Boxer?

No. Sidewall PSI is a maximum. The Boxer placard is the operating target, near 35-45/45-65 psi.

Front versus rear on the Dangel Boxer?

This row is 35-45 F / 45-65 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

When does TPMS warn on a Dangel Boxer?

Direct TPMS typically flags about 25% below placard — near 30 psi on this row. Fill to the sticker, not to the lamp.

How often should I check a Boxer?

Monthly, before a long trip, and after a 10 °C weather swing. Include a full-size spare.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

Handbook: placard · bar vs PSI · front vs rear · cold inflation