UK · EU reference Tyre Pressure

215/65R16 · SUV / crossover · PSI

What PSI for 215/65R16 tyres?

Size
215/65R16
Class
SUV / crossover
Planning PSI
33
Planning bar
2.28

psi

33

2.28 bar · 228 kPa · SUV / crossover planning figure

215/65R16 · 33 psi · 2.28 bar · 228 kPa — estimates. Placard wins.

If someone typed “215/65R16 psi”, they want Imperial. Start near 33 psi on an unladen SUV / crossover, then confirm the vehicle placard. Sidewall max is not the target. A 10 °C overnight drop takes roughly 1 psi (0.07 bar) off a closed 215/65R16.

Estimated 215/65R16 pressure by load

These 215/65R16 load steps are ± a few PSI from 33. They are not a licence to ignore a printed second column on a van or estate.

ConditionFront (est.)Rear (est.)
Driver only / unladen33 psi / 2.28 bar / 228 kPa34 psi / 2.34 bar / 234 kPa
Typical occupancy34 psi / 2.34 bar / 234 kPa36 psi / 2.48 bar / 248 kPa
Motorway + luggage (sketch)35 psi / 2.41 bar / 241 kPa37 psi / 2.55 bar / 255 kPa

PSI, bar and kPa

Use the table, then set a cold gauge. 228 kPa is 100 × 2.28 bar on this size.

PSIBarkPa
292.00200
302.07207
312.14214
322.21221
332.28228
342.34234
352.41241
362.48248
372.55255
382.62262
392.69269
402.76276
412.83283
422.90290
432.96296
443.03303
453.10310

What 215/65R16 means

Read 215/65R16 as width / aspect R rim. Nothing in the size string is a pressure. Pressure lives on the car, not moulded as 205 or 55.

Compact crossover 16-inch. Rim diameter 16 in; section 215 mm. Estimates on this page assume a typical load index for the SUV / crossover class.

Placard versus sidewall

This website maps size searches such as “215/65R16 psi”. It does not replace the VIN label. If the two disagree, the label wins.

Cars often seen on 215/65R16

These catalogue models are often seen on 215/65R16 or a close OEM neighbour. Open the vehicle chart for axle-specific PSI and bar.

How to set 215/65R16

  1. Park so the 215/65R16 tyres are cold (three hours, or less than about a mile).
  2. Read the door-pillar placard for that car — not the 215/65R16 sidewall maximum.
  3. If the sticker is missing, 33 psi / 2.28 bar is only a SUV / crossover planning figure for this size.
  4. Set all four with a calibrated gauge. A 3 psi miss on one corner shows up as a wander.
  5. Refit valve caps and reset TPMS if the handbook asks for a relearn.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 33 psi as a 20 °C baseline for 215/65R16.

AmbientGaugeBarkPaNote
−5 °C (hard frost)30 psi2.07 bar207 kPaGauge reads low; do not overfill once warm
0 °C31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)33 psi2.28 bar228 kPaBaseline for this size sketch
30 °C35 psi2.41 bar241 kPaDo not bleed a hot 215/65R16
38 °C (heatwave tarmac)36 psi2.48 bar248 kPaDo not bleed a hot 215/65R16

Keep 215/65R16 on the printed band for that car; 33 psi is a size sketch, not a second VIN label.

Questions about 215/65R16

Is 215/65R16 the same as a plus-size swap?

Only if that is the size you fitted. Overall diameter should stay close to OEM. Pressure still follows the car, with load index at or above original.

What is 215/65R16 in bar?

33 psi is 2.28 bar. Add a tenth of a bar if the placard’s laden column is higher, which is common on vans that wear this size.

Can I run 215/65R16 at a lower pressure for comfort?

Not as a habit. A soft 215/65R16 cooks the shoulders and dulls steering. Keep load index and stay on the placard.

What is 215/65R16 in kPa?

228 kPa is the planning midpoint (100 kPa = 1 bar). 234 kPa is one PSI higher.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

Handbook: placard · bar vs PSI · cold inflation · all sizes