UK · EU reference Tyre Pressure

DAF · 400 · Bar

DAF 400 bar chart (2.4-3.1 / 3.1-4.5)

Drivetrain
front-wheel drive
Body
light commercial
PSI F / R
35-45 / 45-65
Bar F / R
2.4-3.1 / 3.1-4.5

bar

2.76 / 3.79

35-45 / 45-65 psi · 276 / 379 kPa

35-45 psi F · 45-65 psi R · 2.4-3.1 / 3.1-4.5 bar · 276/379 kPa

European and UK handbooks usually quote bar. The DAF 400 catalogue is 2.4-3.1 bar front and 3.1-4.5 bar rear (midpoint 2.76 / 3.79). TPMS typically warns near 30 psi (about 25% below target). That is already a soft tyre, not a fill target.

Bar, PSI and kPa

Bar-led conversions around the DAF 400. 2.4-3.1 bar is not “35-45 divided by ten”.

BarPSIkPa
2.4135241
2.4836248
2.6238262
2.7640276
3.0344303
3.1045310
3.4550345
3.7955379
4.1460414
4.4865448

DAF 400 placard versus sidewall

If the DAF sticker is painted over, the handbook is next. This website is a map, not a replacement VIN label.

Estimated pressure by tyre size (275/65R18 and others)

Planning cold pressures for sizes often seen on a light commercial. This 400 sample opens with 275/65R18, then 255/65R17 and LT245/75R16.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
275/65R1843612.964.21296421Plus-size 18-inch
255/65R1743602.964.14296414Highway 17-inch
LT245/75R1648673.314.62331462LT-metric, higher load
265/70R1743602.964.14296414Typical 17-inch load tyre
235/75R1541582.834283400Older compact truck
285/70R1744623.034.27303427Wide all-terrain
LT265/70R1748693.314.76331476LT 17-inch
245/70R1642592.94.07290407Common 16-inch all-terrain

Load notes

Load moves the rear of a light commercial first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only40 psi / 2.76 bar55 psi / 3.79 bar
Full occupancy40 psi / 2.76 bar56 psi / 3.86 bar
Motorway + luggage41 psi / 2.83 bar57 psi / 3.93 bar

How to set the 400

  1. Park the DAF 400 for at least three hours (cold tyres).
  2. Use a calibrated gauge, not the only meter on a forecourt hose.
  3. Set the placard for that axle — about 35-45 psi / 2.4-3.1 bar front and 45-65 psi / 3.1-4.5 bar rear on this catalogue row.
  4. Recheck all four. A 2 psi miss on a front-wheel drive 400 is enough to feel a pull.
  5. Refit valve caps and reset TPMS if the handbook asks for a relearn.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 40 psi as a 20 °C baseline for this 400.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)37 psi2.55 bar255 kPaGauge reads low; do not overfill once warm
0 °C38 psi2.62 bar262 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)39 psi2.69 bar269 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)40 psi2.76 bar276 kPaBaseline
30 °C42 psi2.9 bar290 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)43 psi2.96 bar296 kPaDo not bleed a hot tyre

DAF notes

No special DAF exception: the 400 uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the DAF 400 usually follows the higher axle (often the rear, near 45-65 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

A cheap gauge and a monthly habit will do more for this 400 than nitrogen upsells.

Other DAF models

Questions about this 400

Front versus rear on the DAF 400?

This row is 35-45 F / 45-65 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

When does TPMS warn on a DAF 400?

Direct TPMS typically flags about 25% below placard — near 30 psi on this row. Fill to the sticker, not to the lamp.

Is the sidewall number correct on a DAF 400?

No. Sidewall PSI is a maximum. The 400 placard is the operating target, near 35-45/45-65 psi.

What tyre pressure should a DAF 400 use?

Catalogue reference is 35-45 psi front and 45-65 psi rear (2.4-3.1 / 3.1-4.5 bar), cold. Confirm on the door-pillar placard.

What PSI if I plus-size toward LT245/75R16?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 275/65R18, 255/65R17 and LT245/75R16 as a planning band.

Handbook: placard · bar vs PSI · front vs rear · cold inflation