Corvette · Stingray · Overview
Corvette Stingray tyre pressure
- Drivetrain
- front-wheel drive
- Body
- passenger car
- PSI F / R
- 32-35 / 32-35
- Bar F / R
- 2.2-2.4 / 2.2-2.4
psi
34 / 34
Catalogue mid-points, front / rear · 2.2-2.4 / 2.2-2.4 bar
32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa
This front-wheel drive passenger car is filed here with a working range of 32-35/32-35 psi. The pillar sticker on your VIN still overrides the website. TPMS typically warns near 25 psi (about 25% below target). That is already a soft tyre, not a fill target.
Spare and inflator kit
A matching full-size spare on the Corvette Stingray usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.
Corvette Stingray placard versus sidewall
The tyre-information placard on a Corvette Stingray sits on the driver’s door pillar (sometimes the fuel-filler flap). Catalogue figures here are a general band: 32-35 / 32-35 psi.
PSI, bar and kPa
1 bar ≈ 14.5 psi; 1 psi ≈ 6.89 kPa. Mid-points on the Stingray: 34 psi = 2.31 bar = 231 kPa.
| PSI | Bar | kPa |
|---|---|---|
| 30 | 2.07 | 207 |
| 32 | 2.21 | 221 |
| 33 | 2.28 | 228 |
| 33.5 | 2.31 | 231 |
| 35 | 2.41 | 241 |
| 36 | 2.48 | 248 |
| 38 | 2.62 | 262 |
| 40 | 2.76 | 276 |
| 44 | 3.03 | 303 |
| 50 | 3.45 | 345 |
| 60 | 4.14 | 414 |
How to set the Stingray
- Measure before the school run, not after the M25.
- Write LF / RF / RR / RL. Do not keep Stingray numbers in your head.
- Add air in short bursts toward 34 psi (2.31 bar) front and 34 psi rear.
- If one corner is 4 psi down, hunt for a nail before you blame the weather.
- Log date, ambient temperature and the four readings.
Temperature and a cold gauge
Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this Stingray.
| Ambient | Gauge (front mid) | Bar | kPa | Note |
|---|---|---|---|---|
| −5 °C (hard frost) | 31 psi | 2.14 bar | 214 kPa | Gauge reads low; do not overfill once warm |
| 0 °C | 32 psi | 2.21 bar | 221 kPa | Gauge reads low; do not overfill once warm |
| 8 °C (UK winter morning) | 33 psi | 2.28 bar | 228 kPa | Gauge reads low; do not overfill once warm |
| 20 °C (set cold here) | 34 psi | 2.34 bar | 234 kPa | Baseline |
| 30 °C | 36 psi | 2.48 bar | 248 kPa | Do not bleed a hot tyre |
| 38 °C (heatwave tarmac) | 37 psi | 2.55 bar | 255 kPa | Do not bleed a hot tyre |
Pressure against load
Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.
| Condition | Front (est.) | Rear (est.) |
|---|---|---|
| Driver only | 34 psi / 2.34 bar | 34 psi / 2.34 bar |
| Full occupancy | 34 psi / 2.34 bar | 35 psi / 2.41 bar |
| Motorway + luggage | 35 psi / 2.41 bar | 38 psi / 2.62 bar |
Estimated pressure by tyre size (275/30R19 and others)
Planning cold pressures for sizes often seen on a passenger car. This Stingray sample opens with 275/30R19, then 275/35R18 and 255/40R17.
| Tyre size | Front PSI | Rear PSI | Front bar | Rear bar | Front kPa | Rear kPa | Note |
|---|---|---|---|---|---|---|---|
| 275/30R19 | 36 | 37 | 2.48 | 2.55 | 248 | 255 | Rear 19-inch |
| 275/35R18 | 36 | 37 | 2.48 | 2.55 | 248 | 255 | Wide rear |
| 255/40R17 | 35 | 36 | 2.41 | 2.48 | 241 | 248 | Rear stagger 17-inch |
| 225/45R17 | 34 | 35 | 2.34 | 2.41 | 234 | 241 | Front sport size |
| 245/40R18 | 35 | 36 | 2.41 | 2.48 | 241 | 248 | Square-ish sport |
| 235/35R19 | 36 | 36 | 2.48 | 2.48 | 248 | 248 | Front 19-inch |
| 225/40R18 | 35 | 35 | 2.41 | 2.41 | 241 | 241 | Front 18-inch |
| 255/35R18 | 35 | 36 | 2.41 | 2.48 | 241 | 248 | Rear stagger 18-inch |
Corvette notes
No special Corvette exception: the Stingray uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.
If the Corvette sticker and this page disagree, the sticker wins.
Other Corvette models
Questions about this Stingray
Front versus rear on the Corvette Stingray?
This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.
What is that in bar and kPa for the Stingray?
Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.
What tyre pressure should a Corvette Stingray use?
Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.
Should I bleed pressure after a motorway run?
No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.
What PSI if I plus-size toward 255/40R17?
Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 275/30R19, 275/35R18 and 255/40R17 as a planning band.
Handbook: placard · bar vs PSI · front vs rear · cold inflation