UK · EU reference Tyre Pressure

Aston Martin · Vantage · PSI

Aston Martin Vantage inflation in PSI (32-35 front, 32-35 rear)

Drivetrain
front-wheel drive
Body
passenger car
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

psi

34 / 34

Catalogue mid-points, front / rear · 2.2-2.4 / 2.2-2.4 bar

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

A Aston Martin Vantage run at sidewall-max (often 44–51 psi) is over-inflated for this passenger car. The operating PSI is 32-35/32-35. A 10 °C overnight drop takes roughly 1 psi (0.07 bar) off a closed Aston Martin tyre.

Aston Martin Vantage placard versus sidewall

If the Aston Martin sticker is painted over, the handbook is next. This website is a map, not a replacement VIN label.

PSI, bar and kPa

PSI-led conversions for the Aston Martin Vantage band (32-35 / 32-35).

PSIBarkPa
302.07207
322.21221
332.28228
33.52.31231
352.41241
362.48248
382.62262
402.76276
443.03303
503.45345
604.14414

Estimated pressure by tyre size (255/40R17 and others)

Planning cold pressures for sizes often seen on a passenger car. This Vantage sample opens with 255/40R17, then 275/35R18 and 245/40R18.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
255/40R1735362.412.48241248Rear stagger 17-inch
275/35R1836372.482.55248255Wide rear
245/40R1835362.412.48241248Square-ish sport
225/40R1835352.412.41241241Front 18-inch
225/45R1734352.342.41234241Front sport size
275/30R1936372.482.55248255Rear 19-inch
255/35R1835362.412.48241248Rear stagger 18-inch
235/35R1936362.482.48248248Front 19-inch

How to set the Vantage

  1. Park the Aston Martin Vantage for at least three hours (cold tyres).
  2. Use a calibrated gauge, not the only meter on a forecourt hose.
  3. Set the placard for that axle — about 32-35 psi / 2.2-2.4 bar front and 32-35 psi / 2.2-2.4 bar rear on this catalogue row.
  4. Recheck all four. A 2 psi miss on a front-wheel drive Vantage is enough to feel a pull.
  5. Refit valve caps and reset TPMS if the handbook asks for a relearn.

Load notes

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy35 psi / 2.41 bar36 psi / 2.48 bar
Motorway + luggage36 psi / 2.48 bar37 psi / 2.55 bar

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this Vantage.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

Aston Martin notes

No special Aston Martin exception: the Vantage uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the Aston Martin Vantage usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

If the Aston Martin sticker and this page disagree, the sticker wins.

Other Aston Martin models

Questions about this Vantage

How often should I check a Vantage?

Monthly, before a long trip, and after a 10 °C weather swing. Include a full-size spare.

What PSI if I plus-size toward 245/40R18?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 255/40R17, 275/35R18 and 245/40R18 as a planning band.

When does TPMS warn on a Aston Martin Vantage?

Direct TPMS typically flags about 25% below placard — near 25 psi on this row. Fill to the sticker, not to the lamp.

Front versus rear on the Aston Martin Vantage?

This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

Is the sidewall number correct on a Aston Martin Vantage?

No. Sidewall PSI is a maximum. The Vantage placard is the operating target, near 32-35/32-35 psi.

Handbook: placard · bar vs PSI · front vs rear · cold inflation