UK · EU reference Tyre Pressure

245/75R16 · pickup / double-cab · Overview

Recommended pressure for 245/75R16 tyres

Size
245/75R16
Class
pickup / double-cab
Planning PSI
35
Planning bar
2.41

245/75R16

35 psi / 2.41 bar

241 kPa · estimates for this size class

245/75R16 · 35 psi · 2.41 bar · 241 kPa — estimates. Placard wins.

Searches for “245/75R16 pressure” usually want a number. Use 35 psi (2.41 bar) only as a sketch; the door-pillar placard on the car that wears this size still wins. Under-inflation cooks the shoulders of a 245/75R16; over-inflation wears the centre rib and bangs every cat’s eye.

What 245/75R16 means

A 245/75R16 on a pickup / double-cab is a geometry. Two cars can share the size and disagree on PSI because mass and axle split differ.

Taller pickup 16-inch. Rim diameter 16 in; section 245 mm. Estimates on this page assume a typical load index for the pickup / double-cab class.

Estimated 245/75R16 pressure by load

Plus-sizing to 245/75R16 from a taller OEM tyre usually keeps the same placard if the load index is equal or higher.

ConditionFront (est.)Rear (est.)
Driver only / unladen35 psi / 2.41 bar / 241 kPa37 psi / 2.55 bar / 255 kPa
Typical occupancy35 psi / 2.41 bar / 241 kPa38 psi / 2.62 bar / 262 kPa
Payload / towing (sketch)36 psi / 2.48 bar / 248 kPa39 psi / 2.69 bar / 269 kPa

PSI, bar and kPa

Convert around the 245/75R16 band. 2.41 bar is about 35 psi — not 23, not 33 unless the maths says so.

PSIBarkPa
312.14214
322.21221
332.28228
342.34234
352.41241
362.48248
372.55255
382.62262
392.69269
402.76276
412.83283
422.90290
432.96296
443.03303
453.10310
463.17317
473.24324

Placard versus sidewall

This website maps size searches such as “245/75R16 psi”. It does not replace the VIN label. If the two disagree, the label wins.

Cars often seen on 245/75R16

These catalogue models are often seen on 245/75R16 or a close OEM neighbour. Open the vehicle chart for axle-specific PSI and bar.

How to set 245/75R16

  1. Park so the 245/75R16 tyres are cold (three hours, or less than about a mile).
  2. Read the door-pillar placard for that car — not the 245/75R16 sidewall maximum.
  3. If the sticker is missing, 35 psi / 2.41 bar is only a pickup / double-cab planning figure for this size.
  4. Set all four with a calibrated gauge. A 3 psi miss on one corner shows up as a wander.
  5. Refit valve caps and reset TPMS if the handbook asks for a relearn.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 35 psi as a 20 °C baseline for 245/75R16.

AmbientGaugeBarkPaNote
−5 °C (hard frost)32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
0 °C33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)34 psi2.34 bar234 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)35 psi2.41 bar241 kPaBaseline for this size sketch
30 °C37 psi2.55 bar255 kPaDo not bleed a hot 245/75R16
38 °C (heatwave tarmac)38 psi2.62 bar262 kPaDo not bleed a hot 245/75R16

Keep 245/75R16 on the printed band for that car; 35 psi is a size sketch, not a second VIN label.

Questions about 245/75R16

What is 245/75R16 in kPa?

241 kPa is the planning midpoint (100 kPa = 1 bar). 248 kPa is one PSI higher.

Is 245/75R16 the same as a plus-size swap?

Only if that is the size you fitted. Overall diameter should stay close to OEM. Pressure still follows the car, with load index at or above original.

What PSI should 245/75R16 tyres be?

A pickup / double-cab planning figure is about 35 psi cold (2.41 bar / 241 kPa). Confirm on the vehicle placard — two cars can share 245/75R16 and not share a sticker.

What is 245/75R16 in bar?

35 psi is 2.41 bar. Add a tenth of a bar if the placard’s laden column is higher, which is common on vans that wear this size.

When does TPMS warn on 245/75R16?

Direct TPMS typically flags about 25% below target — near 26 psi if you were aiming at 35. Fill to the sticker, not to the lamp.

Handbook: placard · bar vs PSI · cold inflation · all sizes