UK · EU reference Tyre Pressure

245/75R16 · pickup / double-cab · Bar

245/75R16 tyre pressure in bar

Size
245/75R16
Class
pickup / double-cab
Planning PSI
35
Planning bar
2.41

bar

2.41

35 psi · 241 kPa · not a second factory sticker

245/75R16 · 35 psi · 2.41 bar · 241 kPa — estimates. Placard wins.

A 245/75R16 C-type or LT carcass can live far above a hatchback bar figure. This page’s 2.41 bar sketch is for the pickup / double-cab class, not every car that can physically mount the tyre. A 10 °C overnight drop takes roughly 1 psi (0.07 bar) off a closed 245/75R16.

Bar, PSI and kPa

Convert around the 245/75R16 band. 2.41 bar is about 35 psi — not 23, not 33 unless the maths says so.

BarPSIkPa
2.1431214
2.2132221
2.2833228
2.3434234
2.4135241
2.4836248
2.5537255
2.6238262
2.6939269
2.7640276
2.8341283
2.9042290
2.9643296
3.0344303
3.1045310
3.1746317
3.2447324

Estimated 245/75R16 pressure by load

These 245/75R16 load steps are ± a few PSI from 35. They are not a licence to ignore a printed second column on a van or estate.

ConditionFront (est.)Rear (est.)
Driver only / unladen35 psi / 2.41 bar / 241 kPa39 psi / 2.69 bar / 269 kPa
Typical occupancy36 psi / 2.48 bar / 248 kPa41 psi / 2.83 bar / 283 kPa
Payload / towing (sketch)37 psi / 2.55 bar / 255 kPa42 psi / 2.9 bar / 290 kPa

Placard versus sidewall

The sidewall of a 245/75R16 may say 51 psi or 350 kPa. That is a carcass maximum. Operating pressure is the tyre-information placard on the driver’s door pillar.

What 245/75R16 means

245/75R16 means a 245 millimetre section width, a sidewall that is 75 percent of that width, on a 16-inch rim. The R is radial construction.

Taller pickup 16-inch. Rim diameter 16 in; section 245 mm. Estimates on this page assume a typical load index for the pickup / double-cab class.

Cars often seen on 245/75R16

These catalogue models are often seen on 245/75R16 or a close OEM neighbour. Open the vehicle chart for axle-specific PSI and bar.

How to set 245/75R16

  1. Measure before the school run, not after the motorway.
  2. Write LF / RF / RR / RL. Do not keep 245/75R16 numbers in your head.
  3. Add air in short bursts toward the placard, using 35 psi only as a map.
  4. If one 245/75R16 is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 35 psi as a 20 °C baseline for 245/75R16.

AmbientGaugeBarkPaNote
−5 °C (hard frost)32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
0 °C33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)34 psi2.34 bar234 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)35 psi2.41 bar241 kPaBaseline for this size sketch
30 °C37 psi2.55 bar255 kPaDo not bleed a hot 245/75R16
38 °C (heatwave tarmac)38 psi2.62 bar262 kPaDo not bleed a hot 245/75R16

If the door sticker and this 245/75R16 page disagree, the sticker wins.

Questions about 245/75R16

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

What is 245/75R16 in kPa?

241 kPa is the planning midpoint (100 kPa = 1 bar). 248 kPa is one PSI higher.

Can I run 245/75R16 at a lower pressure for comfort?

Not as a habit. A soft 245/75R16 cooks the shoulders and dulls steering. Keep load index and stay on the placard.

What PSI should 245/75R16 tyres be?

A pickup / double-cab planning figure is about 35 psi cold (2.41 bar / 241 kPa). Confirm on the vehicle placard — two cars can share 245/75R16 and not share a sticker.

What is 245/75R16 in bar?

35 psi is 2.41 bar. Add a tenth of a bar if the placard’s laden column is higher, which is common on vans that wear this size.

Handbook: placard · bar vs PSI · cold inflation · all sizes