UK · EU reference Tyre Pressure

245/45R18 · passenger car · Overview

245/45R18 tyre pressure

Size
245/45R18
Class
passenger car
Planning PSI
36
Planning bar
2.48

245/45R18

36 psi / 2.48 bar

248 kPa · estimates for this size class

245/45R18 · 36 psi · 2.48 bar · 248 kPa — estimates. Placard wins.

245/45R18 is a passenger car size (245 mm section, 45 % aspect, 18-inch rim). A planning cold figure around 36 psi / 2.48 bar / 248 kPa is a starting map, not a second factory sticker. 18-inch saloon / GT. These rows are estimates interpolated for the size, not OEM for a named VIN. Low-profile {sz} does not want a “softer” pressure to recover ride. Stay at or slightly above the car’s original placard if load index is kept.

What 245/45R18 means

A 245/45R18 on a passenger car is a geometry. Two cars can share the size and disagree on PSI because mass and axle split differ.

18-inch saloon / GT. Rim diameter 18 in; section 245 mm. Estimates on this page assume a typical load index for the passenger car class.

Estimated 245/45R18 pressure by load

Plus-sizing to 245/45R18 from a taller OEM tyre usually keeps the same placard if the load index is equal or higher.

ConditionFront (est.)Rear (est.)
Driver only / unladen36 psi / 2.48 bar / 248 kPa36 psi / 2.48 bar / 248 kPa
Typical occupancy37 psi / 2.55 bar / 255 kPa38 psi / 2.62 bar / 262 kPa
Motorway + luggage (sketch)38 psi / 2.62 bar / 262 kPa39 psi / 2.69 bar / 269 kPa

PSI, bar and kPa

Convert around the 245/45R18 band. 2.48 bar is about 36 psi — not 23, not 33 unless the maths says so.

PSIBarkPa
322.21221
332.28228
342.34234
352.41241
362.48248
372.55255
382.62262
392.69269
402.76276
412.83283
422.90290
432.96296
443.03303
453.10310
463.17317
473.24324
483.31331

Placard versus sidewall

This website maps size searches such as “245/45R18 psi”. It does not replace the VIN label. If the two disagree, the label wins.

Cars often seen on 245/45R18

These catalogue models are often seen on 245/45R18 or a close OEM neighbour. Open the vehicle chart for axle-specific PSI and bar.

How to set 245/45R18

  1. Measure before the school run, not after the motorway.
  2. Write LF / RF / RR / RL. Do not keep 245/45R18 numbers in your head.
  3. Add air in short bursts toward the placard, using 36 psi only as a map.
  4. If one 245/45R18 is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 36 psi as a 20 °C baseline for 245/45R18.

AmbientGaugeBarkPaNote
−5 °C (hard frost)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
0 °C34 psi2.34 bar234 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)35 psi2.41 bar241 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)36 psi2.48 bar248 kPaBaseline for this size sketch
30 °C38 psi2.62 bar262 kPaDo not bleed a hot 245/45R18
38 °C (heatwave tarmac)39 psi2.69 bar269 kPaDo not bleed a hot 245/45R18

Keep 245/45R18 on the printed band for that car; 36 psi is a size sketch, not a second VIN label.

Questions about 245/45R18

Is the sidewall number correct for 245/45R18?

No. Sidewall PSI or kPa is a maximum for the carcass. Operating pressure is the door-pillar placard.

What is 245/45R18 in kPa?

248 kPa is the planning midpoint (100 kPa = 1 bar). 255 kPa is one PSI higher.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

Is 245/45R18 the same as a plus-size swap?

Only if that is the size you fitted. Overall diameter should stay close to OEM. Pressure still follows the car, with load index at or above original.

Can I run 245/45R18 at a lower pressure for comfort?

Not as a habit. A soft 245/45R18 cooks the shoulders and dulls steering. Keep load index and stay on the placard.

Handbook: placard · bar vs PSI · cold inflation · all sizes