UK · EU reference Tyre Pressure

245/45R18 · passenger car · Bar

245/45R18 tyre pressure in bar

Size
245/45R18
Class
passenger car
Planning PSI
36
Planning bar
2.48

bar

2.48

36 psi · 248 kPa · not a second factory sticker

245/45R18 · 36 psi · 2.48 bar · 248 kPa — estimates. Placard wins.

European stickers print bar. 245/45R18 often sits near 2.48 bar on a passenger car (36 psi / 248 kPa). 2.48 bar is not “36 divided by ten”. TPMS typically warns near 27 psi (about 25% below a 36 psi target). That is already a soft tyre. Low-profile {sz} does not want a “softer” pressure to recover ride. Stay at or slightly above the car’s original placard if load index is kept.

Bar, PSI and kPa

Use the table, then set a cold gauge. 248 kPa is 100 × 2.48 bar on this size.

BarPSIkPa
2.2132221
2.2833228
2.3434234
2.4135241
2.4836248
2.5537255
2.6238262
2.6939269
2.7640276
2.8341283
2.9042290
2.9643296
3.0344303
3.1045310
3.1746317
3.2447324
3.3148331

Estimated 245/45R18 pressure by load

Plus-sizing to 245/45R18 from a taller OEM tyre usually keeps the same placard if the load index is equal or higher.

ConditionFront (est.)Rear (est.)
Driver only / unladen36 psi / 2.48 bar / 248 kPa36 psi / 2.48 bar / 248 kPa
Typical occupancy37 psi / 2.55 bar / 255 kPa38 psi / 2.62 bar / 262 kPa
Motorway + luggage (sketch)38 psi / 2.62 bar / 262 kPa39 psi / 2.69 bar / 269 kPa

Placard versus sidewall

If a forum says “all 245/45R18 run 36 psi”, ignore it. A Qashqai and a Golf can share a size and not share a sticker.

What 245/45R18 means

245/45R18 means a 245 millimetre section width, a sidewall that is 45 percent of that width, on a 18-inch rim. The R is radial construction.

18-inch saloon / GT. Rim diameter 18 in; section 245 mm. Estimates on this page assume a typical load index for the passenger car class.

Cars often seen on 245/45R18

These catalogue models are often seen on 245/45R18 or a close OEM neighbour. Open the vehicle chart for axle-specific PSI and bar.

How to set 245/45R18

  1. Measure before the school run, not after the motorway.
  2. Write LF / RF / RR / RL. Do not keep 245/45R18 numbers in your head.
  3. Add air in short bursts toward the placard, using 36 psi only as a map.
  4. If one 245/45R18 is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 36 psi as a 20 °C baseline for 245/45R18.

AmbientGaugeBarkPaNote
−5 °C (hard frost)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
0 °C34 psi2.34 bar234 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)35 psi2.41 bar241 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)36 psi2.48 bar248 kPaBaseline for this size sketch
30 °C38 psi2.62 bar262 kPaDo not bleed a hot 245/45R18
38 °C (heatwave tarmac)39 psi2.69 bar269 kPaDo not bleed a hot 245/45R18

Keep 245/45R18 on the printed band for that car; 36 psi is a size sketch, not a second VIN label.

Questions about 245/45R18

What is 245/45R18 in kPa?

248 kPa is the planning midpoint (100 kPa = 1 bar). 255 kPa is one PSI higher.

Is 245/45R18 the same as a plus-size swap?

Only if that is the size you fitted. Overall diameter should stay close to OEM. Pressure still follows the car, with load index at or above original.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

What is 245/45R18 in bar?

36 psi is 2.48 bar. Add a tenth of a bar if the placard’s laden column is higher, which is common on vans that wear this size.

When does TPMS warn on 245/45R18?

Direct TPMS typically flags about 25% below target — near 27 psi if you were aiming at 36. Fill to the sticker, not to the lamp.

Handbook: placard · bar vs PSI · cold inflation · all sizes