UK · EU reference Tyre Pressure

Toyota · Fortuner · Overview

Tyre pressure chart for the Toyota Fortuner

Drivetrain
front-wheel drive
Body
passenger car
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

psi

34 / 34

Catalogue mid-points, front / rear · 2.2-2.4 / 2.2-2.4 bar

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

On a Toyota Fortuner the useful pair is 34 psi (2.31 bar) up front and 34 psi (2.31 bar) at the back, mid-range. Under-inflation cooks the shoulders of a Fortuner; over-inflation wears the centre rib and bangs every cat’s eye.

Temperature and a cold gauge

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this Fortuner.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

Pressure against load

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy34 psi / 2.34 bar35 psi / 2.41 bar
Motorway + luggage35 psi / 2.41 bar36 psi / 2.48 bar

Toyota notes

Toyota trucks print front and rear separately more often than cars. A roof box on a RAV4 is a load condition, not a forum “add 5 psi” rule.

Toyota Fortuner placard versus sidewall

The tyre-information placard on a Toyota Fortuner sits on the driver’s door pillar (sometimes the fuel-filler flap). Catalogue figures here are a general band: 32-35 / 32-35 psi.

PSI, bar and kPa

1 bar ≈ 14.5 psi; 1 psi ≈ 6.89 kPa. Mid-points on the Fortuner: 34 psi = 2.31 bar = 231 kPa.

PSIBarkPa
302.07207
322.21221
332.28228
33.52.31231
352.41241
362.48248
382.62262
402.76276
443.03303
503.45345
604.14414

Estimated pressure by tyre size (205/55R16 and others)

If your Toyota Fortuner no longer wears the OEM diameter, start at the row nearest 205/55R16 or 225/50R17 and confirm with the tyre maker’s load table.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
205/55R1634342.342.34234234Typical mid-compact OEM
225/50R1735352.412.41241241Touring 17-inch
225/45R1735352.412.41241241Sport 17-inch
215/50R1735352.412.41241241Plus-size 17-inch
225/40R1836362.482.48248248Low-profile 18-inch
195/65R1534342.342.34234234Very common compact
215/55R1634352.342.41234241Slightly wider 16-inch
245/40R1836362.482.48248248Wide touring 18-inch

Spare and inflator kit

A matching full-size spare on the Toyota Fortuner usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

How to set the Fortuner

  1. Park the Toyota Fortuner for at least three hours (cold tyres).
  2. Use a calibrated gauge, not the only meter on a forecourt hose.
  3. Set the placard for that axle — about 32-35 psi / 2.2-2.4 bar front and 32-35 psi / 2.2-2.4 bar rear on this catalogue row.
  4. Recheck all four. A 2 psi miss on a front-wheel drive Fortuner is enough to feel a pull.
  5. Refit valve caps and reset TPMS if the handbook asks for a relearn.

A cheap gauge and a monthly habit will do more for this Fortuner than nitrogen upsells.

Other Toyota models

Questions about this Fortuner

How often should I check a Fortuner?

Monthly, before a long trip, and after a 10 °C weather swing. Include a full-size spare.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

What PSI if I plus-size toward 225/45R17?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 205/55R16, 225/50R17 and 225/45R17 as a planning band.

What tyre pressure should a Toyota Fortuner use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

Front versus rear on the Toyota Fortuner?

This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

Handbook: placard · bar vs PSI · front vs rear · cold inflation