Toyota · Crown · Rear

Toyota Crown rear tyres: 32-35 psi / 2.2-2.4 bar

Drivetrain: front-wheel drive
Body: passenger car
PSI F / R: 32-35 / 32-35
Bar F / R: 2.2-2.4 / 2.2-2.4

psi rear

2.31 bar · 231 kPa at the rear axle

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

The rear of a passenger car takes passengers, luggage and, on vans, payload. Catalogue rear pressure on the Toyota Crown is 32-35 psi / 2.2-2.4 bar. Size estimates on this page include 245/40R18, 225/45R17 and 195/65R15 — interpolated from the catalogue midpoint, not a second factory sticker.

Toyota Crown placard versus sidewall

If the Toyota sticker is painted over, the handbook is next. This website is a map, not a replacement VIN label.

Estimated pressure by tyre size (245/40R18 and others)

245/40R18 is the first planning size here. 195/65R15 is usually the plus-size or LT step. Keep load index at or above original equipment.

Tyre size	Front PSI	Rear PSI	Front bar	Rear bar	Front kPa	Rear kPa	Note
245/40R18	—	36	—	2.48	—	248	Wide touring 18-inch
225/45R17	—	35	—	2.41	—	241	Sport 17-inch
195/65R15	—	34	—	2.34	—	234	Very common compact
215/50R17	—	35	—	2.41	—	241	Plus-size 17-inch
215/55R16	—	35	—	2.41	—	241	Slightly wider 16-inch
225/50R17	—	35	—	2.41	—	241	Touring 17-inch
185/65R15	—	33	—	2.28	—	228	Small / older car
205/55R16	—	34	—	2.34	—	234	Typical mid-compact OEM

Pressure against load

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

Condition	Front (est.)	Rear (est.)
Driver only	34 psi / 2.34 bar	34 psi / 2.34 bar
Full occupancy	35 psi / 2.41 bar	36 psi / 2.48 bar
Motorway + luggage	36 psi / 2.48 bar	37 psi / 2.55 bar

A family passenger car with a boot full of luggage should use the laden rear figure if Ford, VW or Mercedes printed one. Otherwise the modest steps in the load table are only a sketch for this Crown.

How to set the Crown

Park the Toyota Crown for at least three hours (cold tyres).
Use a calibrated gauge, not the only meter on a forecourt hose.
Set the placard for that axle — about 32-35 psi / 2.2-2.4 bar front and 32-35 psi / 2.2-2.4 bar rear on this catalogue row.
Recheck all four. A 2 psi miss on a front-wheel drive Crown is enough to feel a pull.
Refit valve caps and reset TPMS if the handbook asks for a relearn.

PSI, bar and kPa

PSI-led conversions for the Toyota Crown band (32-35 / 32-35).

PSI	Bar	kPa
30	2.07	207
32	2.21	221
33	2.28	228
33.5	2.31	231
35	2.41	241
36	2.48	248
38	2.62	262
40	2.76	276
44	3.03	303
50	3.45	345
60	4.14	414

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this Crown.

Ambient	Gauge (front mid)	Bar	kPa	Note
−5 °C (hard frost)	31 psi	2.14 bar	214 kPa	Gauge reads low; do not overfill once warm
0 °C	32 psi	2.21 bar	221 kPa	Gauge reads low; do not overfill once warm
8 °C (UK winter morning)	33 psi	2.28 bar	228 kPa	Gauge reads low; do not overfill once warm
20 °C (set cold here)	34 psi	2.34 bar	234 kPa	Baseline
30 °C	36 psi	2.48 bar	248 kPa	Do not bleed a hot tyre
38 °C (heatwave tarmac)	37 psi	2.55 bar	255 kPa	Do not bleed a hot tyre

Toyota notes

Toyota trucks print front and rear separately more often than cars. A roof box on a RAV4 is a load condition, not a forum “add 5 psi” rule.

Spare and inflator kit

A matching full-size spare on the Toyota Crown usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

If the Toyota sticker and this page disagree, the sticker wins.

Other Toyota models

Coaster Celica Belta Avalon Corolla Aygo Camry Avensis Verso

Questions about this Crown

Front versus rear on the Toyota Crown?

This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

What tyre pressure should a Toyota Crown use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

What PSI if I plus-size toward 195/65R15?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 245/40R18, 225/45R17 and 195/65R15 as a planning band.

What is that in bar and kPa for the Crown?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

Handbook: placard · bar vs PSI · front vs rear · cold inflation