Tazzari EV · Zero City · Rear

Tazzari EV Zero City rear tyres: 32-35 psi / 2.2-2.4 bar

Drivetrain: front-wheel drive
Body: passenger car
PSI F / R: 32-35 / 32-35
Bar F / R: 2.2-2.4 / 2.2-2.4

psi rear

2.31 bar · 231 kPa at the rear axle

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

The rear of a passenger car takes passengers, luggage and, on vans, payload. Catalogue rear pressure on the Tazzari EV Zero City is 32-35 psi / 2.2-2.4 bar. Size estimates on this page include 245/40R18, 225/40R18 and 225/45R17 — interpolated from the catalogue midpoint, not a second factory sticker. Battery mass on this {make} {model} makes a 4 psi-low tyre cost range as well as heat.

Tazzari EV Zero City placard versus sidewall

If the Tazzari EV sticker is painted over, the handbook is next. This website is a map, not a replacement VIN label.

Estimated pressure by tyre size (245/40R18 and others)

Planning cold pressures for sizes often seen on a passenger car. This Zero City sample opens with 245/40R18, then 225/40R18 and 225/45R17.

Tyre size	Front PSI	Rear PSI	Front bar	Rear bar	Front kPa	Rear kPa	Note
245/40R18	—	36	—	2.48	—	248	Wide touring 18-inch
225/40R18	—	36	—	2.48	—	248	Low-profile 18-inch
225/45R17	—	35	—	2.41	—	241	Sport 17-inch
205/60R16	—	34	—	2.34	—	234	Taller 16-inch
185/65R15	—	33	—	2.28	—	228	Small / older car
255/40R19	—	37	—	2.55	—	255	EV 19-inch aero wheel
195/65R15	—	34	—	2.34	—	234	Very common compact
225/50R17	—	35	—	2.41	—	241	Touring 17-inch

Pressure against load

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

Condition	Front (est.)	Rear (est.)
Driver only	34 psi / 2.34 bar	34 psi / 2.34 bar
Full occupancy	34 psi / 2.34 bar	35 psi / 2.41 bar
Motorway + luggage	35 psi / 2.41 bar	36 psi / 2.48 bar

A family passenger car with a boot full of luggage should use the laden rear figure if Ford, VW or Mercedes printed one. Otherwise the modest steps in the load table are only a sketch for this Zero City.

How to set the Zero City

Measure before the school run, not after the M25.
Write LF / RF / RR / RL. Do not keep Zero City numbers in your head.
Add air in short bursts toward 34 psi (2.31 bar) front and 34 psi rear.
If one corner is 4 psi down, hunt for a nail before you blame the weather.
Log date, ambient temperature and the four readings.

PSI, bar and kPa

PSI-led conversions for the Tazzari EV Zero City band (32-35 / 32-35).

PSI	Bar	kPa
30	2.07	207
32	2.21	221
33	2.28	228
33.5	2.31	231
35	2.41	241
36	2.48	248
38	2.62	262
40	2.76	276
44	3.03	303
50	3.45	345
60	4.14	414

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this Zero City.

Ambient	Gauge (front mid)	Bar	kPa	Note
−5 °C (hard frost)	31 psi	2.14 bar	214 kPa	Gauge reads low; do not overfill once warm
0 °C	32 psi	2.21 bar	221 kPa	Gauge reads low; do not overfill once warm
8 °C (UK winter morning)	33 psi	2.28 bar	228 kPa	Gauge reads low; do not overfill once warm
20 °C (set cold here)	34 psi	2.34 bar	234 kPa	Baseline
30 °C	36 psi	2.48 bar	248 kPa	Do not bleed a hot tyre
38 °C (heatwave tarmac)	37 psi	2.55 bar	255 kPa	Do not bleed a hot tyre

Tazzari EV notes

No special Tazzari EV exception: the Zero City uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the Tazzari EV Zero City usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

A cheap gauge and a monthly habit will do more for this Zero City than nitrogen upsells.

Other Tazzari EV models

EM1 Anniversary Zero Speedster EM1 Citysport Zero Special Edition Zero SE Zero EM1 Zero EM2 Zero Evo

Questions about this Zero City

Front versus rear on the Tazzari EV Zero City?

This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

When does TPMS warn on a Tazzari EV Zero City?

Direct TPMS typically flags about 25% below placard — near 25 psi on this row. Fill to the sticker, not to the lamp.

Is the sidewall number correct on a Tazzari EV Zero City?

No. Sidewall PSI is a maximum. The Zero City placard is the operating target, near 32-35/32-35 psi.

What tyre pressure should a Tazzari EV Zero City use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

What PSI if I plus-size toward 225/45R17?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 245/40R18, 225/40R18 and 225/45R17 as a planning band.

Handbook: placard · bar vs PSI · front vs rear · cold inflation