Talbot · Matra Rancho · Recommended

Recommended tyre pressure for a Talbot Matra Rancho

Drivetrain: front-wheel drive
Body: passenger car
PSI F / R: 32-35 / 32-35
Bar F / R: 2.2-2.4 / 2.2-2.4

psi

34 / 34

Catalogue mid-points, front / rear · 2.2-2.4 / 2.2-2.4 bar

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

Treat this page as a map of the Matra Rancho band. The legal setpoint is the printed door-pillar label for your VIN. Under-inflation cooks the shoulders of a Matra Rancho; over-inflation wears the centre rib and bangs every cat’s eye.

How to set the Matra Rancho

Measure before the school run, not after the M25.
Write LF / RF / RR / RL. Do not keep Matra Rancho numbers in your head.
Add air in short bursts toward 34 psi (2.31 bar) front and 34 psi rear.
If one corner is 4 psi down, hunt for a nail before you blame the weather.
Log date, ambient temperature and the four readings.

Talbot Matra Rancho placard versus sidewall

Sidewall PSI is a carcass maximum. Recommended operating pressure for this Matra Rancho is the pillar sticker, near 34/34 psi.

Estimated pressure by tyre size (215/55R16 and others)

If your Talbot Matra Rancho no longer wears the OEM diameter, start at the row nearest 215/55R16 or 225/45R17 and confirm with the tyre maker’s load table.

Tyre size	Front PSI	Rear PSI	Front bar	Rear bar	Front kPa	Rear kPa	Note
215/55R16	34	35	2.34	2.41	234	241	Slightly wider 16-inch
225/45R17	35	35	2.41	2.41	241	241	Sport 17-inch
245/40R18	36	36	2.48	2.48	248	248	Wide touring 18-inch
215/50R17	35	35	2.41	2.41	241	241	Plus-size 17-inch
185/65R15	33	33	2.28	2.28	228	228	Small / older car
205/55R16	34	34	2.34	2.34	234	234	Typical mid-compact OEM
205/60R16	34	34	2.34	2.34	234	234	Taller 16-inch
225/50R17	35	35	2.41	2.41	241	241	Touring 17-inch

PSI, bar and kPa

PSI-led conversions for the Talbot Matra Rancho band (32-35 / 32-35).

PSI	Bar	kPa
30	2.07	207
32	2.21	221
33	2.28	228
33.5	2.31	231
35	2.41	241
36	2.48	248
38	2.62	262
40	2.76	276
44	3.03	303
50	3.45	345
60	4.14	414

Pressure against load

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

Condition	Front (est.)	Rear (est.)
Driver only	34 psi / 2.34 bar	34 psi / 2.34 bar
Full occupancy	35 psi / 2.41 bar	36 psi / 2.48 bar
Motorway + luggage	36 psi / 2.48 bar	36 psi / 2.48 bar

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this Matra Rancho.

Ambient	Gauge (front mid)	Bar	kPa	Note
−5 °C (hard frost)	31 psi	2.14 bar	214 kPa	Gauge reads low; do not overfill once warm
0 °C	32 psi	2.21 bar	221 kPa	Gauge reads low; do not overfill once warm
8 °C (UK winter morning)	33 psi	2.28 bar	228 kPa	Gauge reads low; do not overfill once warm
20 °C (set cold here)	34 psi	2.34 bar	234 kPa	Baseline
30 °C	36 psi	2.48 bar	248 kPa	Do not bleed a hot tyre
38 °C (heatwave tarmac)	37 psi	2.55 bar	255 kPa	Do not bleed a hot tyre

Talbot notes

No special Talbot exception: the Matra Rancho uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the Talbot Matra Rancho usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

A cheap gauge and a monthly habit will do more for this Matra Rancho than nitrogen upsells.

Other Talbot models

Simca 1510 Samba Tagora Sunbeam Alpine Solar LS Simca 1100 Horizon

Questions about this Matra Rancho

Front versus rear on the Talbot Matra Rancho?

This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

What is that in bar and kPa for the Matra Rancho?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

What tyre pressure should a Talbot Matra Rancho use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

What PSI if I plus-size toward 245/40R18?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 215/55R16, 225/45R17 and 245/40R18 as a planning band.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

Handbook: placard · bar vs PSI · front vs rear · cold inflation