Suzuki · LJ 80 · Bar

Recommended bar for a Suzuki LJ 80

Drivetrain: front-wheel drive
Body: passenger car
PSI F / R: 32-35 / 32-35
Bar F / R: 2.2-2.4 / 2.2-2.4

bar

2.31 / 2.31

32-35 / 32-35 psi · 231 / 231 kPa

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

European and UK handbooks usually quote bar. The Suzuki LJ 80 catalogue is 2.2-2.4 bar front and 2.2-2.4 bar rear (midpoint 2.31 / 2.31). A 10 °C overnight drop takes roughly 1 psi (0.07 bar) off a closed Suzuki tyre.

Bar, PSI and kPa

Bar-led conversions around the Suzuki LJ 80. 2.2-2.4 bar is not “32-35 divided by ten”.

Bar	PSI	kPa
2.07	30	207
2.21	32	221
2.28	33	228
2.31	33.5	231
2.41	35	241
2.48	36	248
2.62	38	262
2.76	40	276
3.03	44	303
3.45	50	345
4.14	60	414

Suzuki LJ 80 placard versus sidewall

If the Suzuki sticker is painted over, the handbook is next. This website is a map, not a replacement VIN label.

Estimated pressure by tyre size (215/50R17 and others)

If your Suzuki LJ 80 no longer wears the OEM diameter, start at the row nearest 215/50R17 or 245/40R18 and confirm with the tyre maker’s load table.

Tyre size	Front PSI	Rear PSI	Front bar	Rear bar	Front kPa	Rear kPa	Note
215/50R17	35	35	2.41	2.41	241	241	Plus-size 17-inch
245/40R18	36	36	2.48	2.48	248	248	Wide touring 18-inch
225/45R17	35	35	2.41	2.41	241	241	Sport 17-inch
205/60R16	34	34	2.34	2.34	234	234	Taller 16-inch
215/55R16	34	35	2.34	2.41	234	241	Slightly wider 16-inch
205/55R16	34	34	2.34	2.34	234	234	Typical mid-compact OEM
195/65R15	34	34	2.34	2.34	234	234	Very common compact
225/50R17	35	35	2.41	2.41	241	241	Touring 17-inch

Load notes

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

Condition	Front (est.)	Rear (est.)
Driver only	34 psi / 2.34 bar	34 psi / 2.34 bar
Full occupancy	34 psi / 2.34 bar	35 psi / 2.41 bar
Motorway + luggage	35 psi / 2.41 bar	36 psi / 2.48 bar

How to set the LJ 80

Measure before the school run, not after the M25.
Write LF / RF / RR / RL. Do not keep LJ 80 numbers in your head.
Add air in short bursts toward 34 psi (2.31 bar) front and 34 psi rear.
If one corner is 4 psi down, hunt for a nail before you blame the weather.
Log date, ambient temperature and the four readings.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this LJ 80.

Ambient	Gauge (front mid)	Bar	kPa	Note
−5 °C (hard frost)	31 psi	2.14 bar	214 kPa	Gauge reads low; do not overfill once warm
0 °C	32 psi	2.21 bar	221 kPa	Gauge reads low; do not overfill once warm
8 °C (UK winter morning)	33 psi	2.28 bar	228 kPa	Gauge reads low; do not overfill once warm
20 °C (set cold here)	34 psi	2.34 bar	234 kPa	Baseline
30 °C	36 psi	2.48 bar	248 kPa	Do not bleed a hot tyre
38 °C (heatwave tarmac)	37 psi	2.55 bar	255 kPa	Do not bleed a hot tyre

Suzuki notes

No special Suzuki exception: the LJ 80 uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the Suzuki LJ 80 usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

Keep the Suzuki LJ 80 on the printed band; use 215/50R17 and 225/45R17 only as a map for non-OEM wheels.

Other Suzuki models

Santana Splash Swace Maruti SJ 410 Across Ik-2 Escudo

Questions about this LJ 80

Front versus rear on the Suzuki LJ 80?

This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

Is the sidewall number correct on a Suzuki LJ 80?

No. Sidewall PSI is a maximum. The LJ 80 placard is the operating target, near 32-35/32-35 psi.

What tyre pressure should a Suzuki LJ 80 use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

What PSI if I plus-size toward 225/45R17?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 215/50R17, 245/40R18 and 225/45R17 as a planning band.

Handbook: placard · bar vs PSI · front vs rear · cold inflation