UK · EU reference Tyre Pressure

Subaru · OUTBACK · Overview

Subaru OUTBACK tyre pressure

Drivetrain
all-wheel drive
Body
SUV / crossover
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

psi

34 / 34

Catalogue mid-points, front / rear · 2.2-2.4 / 2.2-2.4 bar

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

This all-wheel drive SUV / crossover is filed here with a working range of 32-35/32-35 psi. The pillar sticker on your VIN still overrides the website. Under-inflation cooks the shoulders of a OUTBACK; over-inflation wears the centre rib and bangs every cat’s eye. Keep side-to-side spread inside about 2 psi so the all-wheel drive hardware is not working on a radius mismatch.

Subaru notes

No special Subaru exception: the OUTBACK uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Estimated pressure by tyre size (225/60R18 and others)

If your Subaru OUTBACK no longer wears the OEM diameter, start at the row nearest 225/60R18 or 225/65R17 and confirm with the tyre maker’s load table.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
225/60R1835352.412.41241241Highway CUV
225/65R1735352.412.41241241Very common 17-inch
235/65R1735362.412.48241248Mid-size SUV
245/55R1936362.482.48248248Low-profile 19-inch
245/60R1836372.482.55248255Heavier CUV
255/50R2037372.552.5525525520-inch plus-size
215/70R1634342.342.34234234Compact crossover
235/60R1836362.482.48248248Plus-size 18-inch

Pressure against load

Load moves the rear of a SUV / crossover first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy34 psi / 2.34 bar35 psi / 2.41 bar
Motorway + luggage35 psi / 2.41 bar36 psi / 2.48 bar

Spare and inflator kit

A matching full-size spare on the Subaru OUTBACK usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

How to set the OUTBACK

  1. Measure before the school run, not after the M25.
  2. Write LF / RF / RR / RL. Do not keep OUTBACK numbers in your head.
  3. Add air in short bursts toward 34 psi (2.31 bar) front and 34 psi rear.
  4. If one corner is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Temperature and a cold gauge

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this OUTBACK.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

PSI, bar and kPa

1 bar ≈ 14.5 psi; 1 psi ≈ 6.89 kPa. Mid-points on the OUTBACK: 34 psi = 2.31 bar = 231 kPa.

PSIBarkPa
302.07207
322.21221
332.28228
33.52.31231
352.41241
362.48248
382.62262
402.76276
443.03303
503.45345
604.14414

Subaru OUTBACK placard versus sidewall

If the Subaru sticker is painted over, the handbook is next. This website is a map, not a replacement VIN label.

If the Subaru sticker and this page disagree, the sticker wins.

Other Subaru models

Questions about this OUTBACK

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

Is the sidewall number correct on a Subaru OUTBACK?

No. Sidewall PSI is a maximum. The OUTBACK placard is the operating target, near 32-35/32-35 psi.

Front versus rear on the Subaru OUTBACK?

This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

What tyre pressure should a Subaru OUTBACK use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

What is that in bar and kPa for the OUTBACK?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

Handbook: placard · bar vs PSI · front vs rear · cold inflation