UK · EU reference Tyre Pressure

Porsche · Macan · Bar

Recommended bar for a Porsche Macan

Drivetrain
all-wheel drive
Body
SUV / crossover
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

bar

2.31 / 2.31

32-35 / 32-35 psi · 231 / 231 kPa

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

2.3 bar is not 23 psi. On this Macan 2.2-2.4 bar converts to about 32-35 psi. Use the table, not a guess. A 10 °C overnight drop takes roughly 1 psi (0.07 bar) off a closed Porsche tyre. Keep side-to-side spread inside about 2 psi so the all-wheel drive hardware is not working on a radius mismatch.

Bar, PSI and kPa

Bar-led conversions around the Porsche Macan. 2.2-2.4 bar is not “32-35 divided by ten”.

BarPSIkPa
2.0730207
2.2132221
2.2833228
2.3133.5231
2.4135241
2.4836248
2.6238262
2.7640276
3.0344303
3.4550345
4.1460414

Porsche Macan placard versus sidewall

If the Porsche sticker is painted over, the handbook is next. This website is a map, not a replacement VIN label.

Estimated pressure by tyre size (235/60R18 and others)

Planning cold pressures for sizes often seen on a SUV / crossover. This Macan sample opens with 235/60R18, then 215/70R16 and 235/65R17.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
235/60R1836362.482.48248248Plus-size 18-inch
215/70R1634342.342.34234234Compact crossover
235/65R1735362.412.48241248Mid-size SUV
245/60R1836372.482.55248255Heavier CUV
255/50R2037372.552.5525525520-inch plus-size
225/60R1835352.412.41241241Highway CUV
225/65R1735352.412.41241241Very common 17-inch
245/55R1936362.482.48248248Low-profile 19-inch

Load notes

Load moves the rear of a SUV / crossover first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy34 psi / 2.34 bar35 psi / 2.41 bar
Motorway + luggage35 psi / 2.41 bar37 psi / 2.55 bar

How to set the Macan

  1. Measure before the school run, not after the M25.
  2. Write LF / RF / RR / RL. Do not keep Macan numbers in your head.
  3. Add air in short bursts toward 34 psi (2.31 bar) front and 34 psi rear.
  4. If one corner is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this Macan.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

Porsche notes

No special Porsche exception: the Macan uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the Porsche Macan usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

If the Porsche sticker and this page disagree, the sticker wins.

Other Porsche models

Questions about this Macan

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

What PSI if I plus-size toward 235/65R17?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 235/60R18, 215/70R16 and 235/65R17 as a planning band.

What is that in bar and kPa for the Macan?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

What tyre pressure should a Porsche Macan use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

Is the sidewall number correct on a Porsche Macan?

No. Sidewall PSI is a maximum. The Macan placard is the operating target, near 32-35/32-35 psi.

Handbook: placard · bar vs PSI · front vs rear · cold inflation