UK · EU reference Tyre Pressure

Peugeot · Boxer · Overview

Peugeot Boxer tyre pressure

Drivetrain
front-wheel drive
Body
van
PSI F / R
35-45 / 45-65
Bar F / R
2.4-3.1 / 3.1-4.5

psi

40 / 55

Catalogue mid-points, front / rear · 2.4-3.1 / 3.1-4.5 bar

35-45 psi F · 45-65 psi R · 2.4-3.1 / 3.1-4.5 bar · 276/379 kPa

This front-wheel drive van is filed here with a working range of 35-45/45-65 psi. The pillar sticker on your VIN still overrides the website. Size estimates on this page include 235/60R17, 195/75R16C and 225/75R16 — interpolated from the catalogue midpoint, not a second factory sticker. Commercial and load-biased bodies like this van often need a higher rear; LT or C-type sizes such as 225/75R16 are not filled like a Fiesta.

How to set the Boxer

  1. Park the Peugeot Boxer for at least three hours (cold tyres).
  2. Use a calibrated gauge, not the only meter on a forecourt hose.
  3. Set the placard for that axle — about 35-45 psi / 2.4-3.1 bar front and 45-65 psi / 3.1-4.5 bar rear on this catalogue row.
  4. Recheck all four. A 2 psi miss on a front-wheel drive Boxer is enough to feel a pull.
  5. Refit valve caps and reset TPMS if the handbook asks for a relearn.

Pressure against load

Load moves the rear of a van first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only40 psi / 2.76 bar55 psi / 3.79 bar
Full occupancy40 psi / 2.76 bar56 psi / 3.86 bar
Payload / towing41 psi / 2.83 bar59 psi / 4.07 bar

Spare and inflator kit

A matching full-size spare on the Peugeot Boxer usually follows the higher axle (often the rear, near 45-65 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

Peugeot notes

Peugeot often prints bar. A 2.4 bar 308 is about 35 psi. Do not copy a Partner van figure onto a hatchback.

Peugeot Boxer placard versus sidewall

The tyre-information placard on a Peugeot Boxer sits on the driver’s door pillar (sometimes the fuel-filler flap). Catalogue figures here are a general band: 35-45 / 45-65 psi.

Estimated pressure by tyre size (235/60R17 and others)

Planning cold pressures for sizes often seen on a van. This Boxer sample opens with 235/60R17, then 195/75R16C and 225/75R16.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
235/60R1741582.834283400Plus-size van
195/75R16C44633.034.34303434C-type commercial
225/75R1642602.94.14290414Taller load range
LT215/85R1646653.174.48317448LT commercial
235/65R1642592.94.07290407Loaded van
225/65R1641582.834283400Common transaxle van
215/65R1640572.763.93276393Compact van
215/75R16C45643.14.41310441C-type 215

PSI, bar and kPa

1 bar ≈ 14.5 psi; 1 psi ≈ 6.89 kPa. Mid-points on the Boxer: 40 psi = 2.76 bar = 276 kPa.

PSIBarkPa
352.41241
362.48248
382.62262
402.76276
443.03303
453.10310
503.45345
553.79379
604.14414
654.48448

Temperature and a cold gauge

Roughly 1 psi per 5–6 °C. The table uses 40 psi as a 20 °C baseline for this Boxer.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)37 psi2.55 bar255 kPaGauge reads low; do not overfill once warm
0 °C38 psi2.62 bar262 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)39 psi2.69 bar269 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)40 psi2.76 bar276 kPaBaseline
30 °C42 psi2.9 bar290 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)43 psi2.96 bar296 kPaDo not bleed a hot tyre

Keep the Peugeot Boxer on the printed band; use 235/60R17 and 225/75R16 only as a map for non-OEM wheels.

Other Peugeot models

Questions about this Boxer

When does TPMS warn on a Peugeot Boxer?

Direct TPMS typically flags about 25% below placard — near 30 psi on this row. Fill to the sticker, not to the lamp.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

Front versus rear on the Peugeot Boxer?

This row is 35-45 F / 45-65 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

Is the sidewall number correct on a Peugeot Boxer?

No. Sidewall PSI is a maximum. The Boxer placard is the operating target, near 35-45/45-65 psi.

How often should I check a Boxer?

Monthly, before a long trip, and after a 10 °C weather swing. Include a full-size spare.

Handbook: placard · bar vs PSI · front vs rear · cold inflation