UK · EU reference Tyre Pressure

Oldtimer · NSU · PSI

Oldtimer NSU inflation in PSI (32-35 front, 32-35 rear)

Drivetrain
front-wheel drive
Body
passenger car
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

psi

34 / 34

Catalogue mid-points, front / rear · 2.2-2.4 / 2.2-2.4 bar

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

A Oldtimer NSU run at sidewall-max (often 44–51 psi) is over-inflated for this passenger car. The operating PSI is 32-35/32-35. Under-inflation cooks the shoulders of a NSU; over-inflation wears the centre rib and bangs every cat’s eye.

Oldtimer NSU placard versus sidewall

Sidewall PSI is a carcass maximum. Recommended operating pressure for this NSU is the pillar sticker, near 34/34 psi.

PSI, bar and kPa

PSI-led conversions for the Oldtimer NSU band (32-35 / 32-35).

PSIBarkPa
302.07207
322.21221
332.28228
33.52.31231
352.41241
362.48248
382.62262
402.76276
443.03303
503.45345
604.14414

Estimated pressure by tyre size (225/40R18 and others)

Planning cold pressures for sizes often seen on a passenger car. This NSU sample opens with 225/40R18, then 225/45R17 and 215/50R17.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
225/40R1836362.482.48248248Low-profile 18-inch
225/45R1735352.412.41241241Sport 17-inch
215/50R1735352.412.41241241Plus-size 17-inch
225/50R1735352.412.41241241Touring 17-inch
215/55R1634352.342.41234241Slightly wider 16-inch
195/65R1534342.342.34234234Very common compact
205/55R1634342.342.34234234Typical mid-compact OEM
245/40R1836362.482.48248248Wide touring 18-inch

How to set the NSU

  1. Measure before the school run, not after the M25.
  2. Write LF / RF / RR / RL. Do not keep NSU numbers in your head.
  3. Add air in short bursts toward 34 psi (2.31 bar) front and 34 psi rear.
  4. If one corner is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Load notes

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy35 psi / 2.41 bar36 psi / 2.48 bar
Motorway + luggage36 psi / 2.48 bar37 psi / 2.55 bar

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this NSU.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

Oldtimer notes

No special Oldtimer exception: the NSU uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the Oldtimer NSU usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

If the Oldtimer sticker and this page disagree, the sticker wins.

Other Oldtimer models

Questions about this NSU

How often should I check a NSU?

Monthly, before a long trip, and after a 10 °C weather swing. Include a full-size spare.

Is the sidewall number correct on a Oldtimer NSU?

No. Sidewall PSI is a maximum. The NSU placard is the operating target, near 32-35/32-35 psi.

What is that in bar and kPa for the NSU?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

Front versus rear on the Oldtimer NSU?

This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

Handbook: placard · bar vs PSI · front vs rear · cold inflation