UK · EU reference Tyre Pressure

Oldtimer · Bizzarrini · Overview

Oldtimer Bizzarrini tyre pressure

Drivetrain
front-wheel drive
Body
passenger car
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

psi

34 / 34

Catalogue mid-points, front / rear · 2.2-2.4 / 2.2-2.4 bar

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

On a Oldtimer Bizzarrini the useful pair is 34 psi (2.31 bar) up front and 34 psi (2.31 bar) at the back, mid-range. A 10 °C overnight drop takes roughly 1 psi (0.07 bar) off a closed Oldtimer tyre.

PSI, bar and kPa

1 bar ≈ 14.5 psi; 1 psi ≈ 6.89 kPa. Mid-points on the Bizzarrini: 34 psi = 2.31 bar = 231 kPa.

PSIBarkPa
302.07207
322.21221
332.28228
33.52.31231
352.41241
362.48248
382.62262
402.76276
443.03303
503.45345
604.14414

Pressure against load

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy34 psi / 2.34 bar35 psi / 2.41 bar
Motorway + luggage35 psi / 2.41 bar37 psi / 2.55 bar

Oldtimer Bizzarrini placard versus sidewall

The tyre-information placard on a Oldtimer Bizzarrini sits on the driver’s door pillar (sometimes the fuel-filler flap). Catalogue figures here are a general band: 32-35 / 32-35 psi.

Spare and inflator kit

A matching full-size spare on the Oldtimer Bizzarrini usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

Oldtimer notes

No special Oldtimer exception: the Bizzarrini uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

How to set the Bizzarrini

  1. Measure before the school run, not after the M25.
  2. Write LF / RF / RR / RL. Do not keep Bizzarrini numbers in your head.
  3. Add air in short bursts toward 34 psi (2.31 bar) front and 34 psi rear.
  4. If one corner is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Temperature and a cold gauge

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this Bizzarrini.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

Estimated pressure by tyre size (245/40R18 and others)

Planning cold pressures for sizes often seen on a passenger car. This Bizzarrini sample opens with 245/40R18, then 225/50R17 and 205/60R16.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
245/40R1836362.482.48248248Wide touring 18-inch
225/50R1735352.412.41241241Touring 17-inch
205/60R1634342.342.34234234Taller 16-inch
215/55R1634352.342.41234241Slightly wider 16-inch
205/55R1634342.342.34234234Typical mid-compact OEM
215/50R1735352.412.41241241Plus-size 17-inch
225/45R1735352.412.41241241Sport 17-inch
185/65R1533332.282.28228228Small / older car

Keep the Oldtimer Bizzarrini on the printed band; use 245/40R18 and 205/60R16 only as a map for non-OEM wheels.

Other Oldtimer models

Questions about this Bizzarrini

What is that in bar and kPa for the Bizzarrini?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

When does TPMS warn on a Oldtimer Bizzarrini?

Direct TPMS typically flags about 25% below placard — near 25 psi on this row. Fill to the sticker, not to the lamp.

Is the sidewall number correct on a Oldtimer Bizzarrini?

No. Sidewall PSI is a maximum. The Bizzarrini placard is the operating target, near 32-35/32-35 psi.

How often should I check a Bizzarrini?

Monthly, before a long trip, and after a 10 °C weather swing. Include a full-size spare.

What tyre pressure should a Oldtimer Bizzarrini use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

Handbook: placard · bar vs PSI · front vs rear · cold inflation