UK · EU reference Tyre Pressure

Oldtimer · Berkeley · Front

Oldtimer Berkeley front tyre pressure

Drivetrain
front-wheel drive
Body
passenger car
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

psi front

34

2.31 bar · 231 kPa at the steering axle

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

A 3 psi miss on one front corner of this Berkeley shows up as a wander before the TPMS lamp bothers you. Target 34 psi (2.31 bar) cold. Under-inflation cooks the shoulders of a Berkeley; over-inflation wears the centre rib and bangs every cat’s eye.

Oldtimer Berkeley placard versus sidewall

The tyre-information placard on a Oldtimer Berkeley sits on the driver’s door pillar (sometimes the fuel-filler flap). Catalogue figures here are a general band: 32-35 / 32-35 psi.

Estimated pressure by tyre size (215/50R17 and others)

If your Oldtimer Berkeley no longer wears the OEM diameter, start at the row nearest 215/50R17 or 205/55R16 and confirm with the tyre maker’s load table.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
215/50R17352.41241Plus-size 17-inch
205/55R16342.34234Typical mid-compact OEM
225/50R17352.41241Touring 17-inch
225/40R18362.48248Low-profile 18-inch
245/40R18362.48248Wide touring 18-inch
215/55R16342.34234Slightly wider 16-inch
205/60R16342.34234Taller 16-inch
225/45R17352.41241Sport 17-inch

Pressure against load

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy34 psi / 2.34 bar35 psi / 2.41 bar
Motorway + luggage35 psi / 2.41 bar36 psi / 2.48 bar

Steering feel on the Berkeley lives on this axle. Do not drop front pressure to “soften” a plus-size 225/50R17; you will roll the sidewall in a roundabout.

How to set the Berkeley

  1. Measure before the school run, not after the M25.
  2. Write LF / RF / RR / RL. Do not keep Berkeley numbers in your head.
  3. Add air in short bursts toward 34 psi (2.31 bar) front and 34 psi rear.
  4. If one corner is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

PSI, bar and kPa

PSI-led conversions for the Oldtimer Berkeley band (32-35 / 32-35).

PSIBarkPa
302.07207
322.21221
332.28228
33.52.31231
352.41241
362.48248
382.62262
402.76276
443.03303
503.45345
604.14414

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this Berkeley.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

Oldtimer notes

No special Oldtimer exception: the Berkeley uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the Oldtimer Berkeley usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

If the Oldtimer sticker and this page disagree, the sticker wins.

Other Oldtimer models

Questions about this Berkeley

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

What PSI if I plus-size toward 225/50R17?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 215/50R17, 205/55R16 and 225/50R17 as a planning band.

What is that in bar and kPa for the Berkeley?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

Is the sidewall number correct on a Oldtimer Berkeley?

No. Sidewall PSI is a maximum. The Berkeley placard is the operating target, near 32-35/32-35 psi.

What tyre pressure should a Oldtimer Berkeley use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

Handbook: placard · bar vs PSI · front vs rear · cold inflation