UK · EU reference Tyre Pressure

Nissan · NV200 · Rear

Nissan NV200 rear tyre pressure

Drivetrain
front-wheel drive
Body
van
PSI F / R
35-45 / 45-65
Bar F / R
2.4-3.1 / 3.1-4.5

psi rear

55

3.79 bar · 379 kPa at the rear axle

35-45 psi F · 45-65 psi R · 2.4-3.1 / 3.1-4.5 bar · 276/379 kPa

Loaded NV200 rears often need the sticker’s second column, not a copy of the front 35-45 psi figure. Under-inflation cooks the shoulders of a NV200; over-inflation wears the centre rib and bangs every cat’s eye. Commercial and load-biased bodies like this van often need a higher rear; LT or C-type sizes such as 235/65R16 are not filled like a Fiesta.

Nissan NV200 placard versus sidewall

If the Nissan sticker is painted over, the handbook is next. This website is a map, not a replacement VIN label.

Estimated pressure by tyre size (225/65R16 and others)

Planning cold pressures for sizes often seen on a van. This NV200 sample opens with 225/65R16, then 235/60R17 and 235/65R16.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
225/65R16584400Common transaxle van
235/60R17584400Plus-size van
235/65R16594.07407Loaded van
195/75R16C634.34434C-type commercial
215/65R16573.93393Compact van
215/75R16C644.41441C-type 215
LT215/85R16654.48448LT commercial
225/75R16604.14414Taller load range

Pressure against load

Load moves the rear of a van first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only40 psi / 2.76 bar55 psi / 3.79 bar
Full occupancy40 psi / 2.76 bar56 psi / 3.86 bar
Payload / towing41 psi / 2.83 bar59 psi / 4.07 bar

A family van with a boot full of luggage should use the laden rear figure if Ford, VW or Mercedes printed one. Otherwise the modest steps in the load table are only a sketch for this NV200.

How to set the NV200

  1. Measure before the school run, not after the M25.
  2. Write LF / RF / RR / RL. Do not keep NV200 numbers in your head.
  3. Add air in short bursts toward 40 psi (2.76 bar) front and 55 psi rear.
  4. If one corner is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

PSI, bar and kPa

PSI-led conversions for the Nissan NV200 band (35-45 / 45-65).

PSIBarkPa
352.41241
362.48248
382.62262
402.76276
443.03303
453.10310
503.45345
553.79379
604.14414
654.48448

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 40 psi as a 20 °C baseline for this NV200.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)37 psi2.55 bar255 kPaGauge reads low; do not overfill once warm
0 °C38 psi2.62 bar262 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)39 psi2.69 bar269 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)40 psi2.76 bar276 kPaBaseline
30 °C42 psi2.9 bar290 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)43 psi2.96 bar296 kPaDo not bleed a hot tyre

Nissan notes

A Qashqai and a Navara do not share a number. Vans and taxis may sit higher than a family hatch.

Spare and inflator kit

A matching full-size spare on the Nissan NV200 usually follows the higher axle (often the rear, near 45-65 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

If the Nissan sticker and this page disagree, the sticker wins.

Other Nissan models

Questions about this NV200

What is that in bar and kPa for the NV200?

Mid-points are about 2.76 bar (276 kPa) front and 3.79 bar (379 kPa) rear.

What PSI if I plus-size toward 235/65R16?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 225/65R16, 235/60R17 and 235/65R16 as a planning band.

Is the sidewall number correct on a Nissan NV200?

No. Sidewall PSI is a maximum. The NV200 placard is the operating target, near 35-45/45-65 psi.

How often should I check a NV200?

Monthly, before a long trip, and after a 10 °C weather swing. Include a full-size spare.

What tyre pressure should a Nissan NV200 use?

Catalogue reference is 35-45 psi front and 45-65 psi rear (2.4-3.1 / 3.1-4.5 bar), cold. Confirm on the door-pillar placard.

Handbook: placard · bar vs PSI · front vs rear · cold inflation